Pierre's 170W in 1600W out Looped Very impressive Build continued & moderated

[gotoluc]

Yes, this is very similar ! Thank You !

See my video: every second coils turn on. When field work is normal, magnet spin itself speed. When push back, magnet spin "2 times fast back more".
Little step forward ...?

https://youtu.be/Rpyoiv1gRts

Very good build and demonstration r2fpl
Thanks for sharing
Luc

[pmgr]

Yes, this is very similar ! Thank You !

See my video: every second coils turn on. When field work is normal, magnet spin itself speed. When push back, magnet spin "2 times fast back more".
Little step forward ...?

https://youtu.be/Rpyoiv1gRts

Can you describe or show a schematic of how and what coils you are turning on and how many are on at the same time and how the Arduino is spinning your field? Schematic would be nice.
PmgR

[r2fpl]

https://youtu.be/1Kl4e5LkCfs

ex.:   digitalWrite(1,on), digitalWrite(13,on), digitalWrite(25,on);

coil 1,13,25     
...
...

stator: cw-cw-cw-cw-cw.....cw      all(+...-)

connection = Pierre schematic diagram

[T-1000]

https://youtu.be/1Kl4e5LkCfs

ex.:   digitalWrite(1,on), digitalWrite(13,on), digitalWrite(25,on);

coil 1,13,25     
...
...

stator: cw-cw-cw-cw-cw.....cw      all(+...-)

connection = Pierre schematic diagram

Seems you are just switching coils off before going next on state. When comparing to physically rotating magnetic pole it would be just on-forcibly-stop then on again. Which is not what we are trying to achieve. Can you try to drive in same way Pierre did? coil 1 on,wait,coil 2 on,wait, coil 1 off, wait, coil 3 on, wait.. and so on with 1-2-1 pattern.

Cheers!

[r2fpl]

Seems you are just switching coils off before going next on state. When comparing to physically rotating magnetic pole it would be just on-forcibly-stop then on again. Which is not what we are trying to achieve. Can you try to drive in same way Pierre did? coil 1 on,wait,coil 2 on,wait, coil 1 off, wait, coil 3 on, wait.. and so on with 1-2-1 pattern.

Cheers!

This is the modified version as a curiosity. Normally it is just like Pierre, and nothing happens after the move. The field is spinning but there is no tension on LOAD.
As in the movie: https://youtu.be/0IKX8MeVQio (= original programm Pierre 1on-2on-1off ...)

Probably the coils must be cw-ccw-cw-ccw .... or else.