Flynn / Lafonte slider - 800% OU possible

[norman6538]

I have made some real progress by serializing several ramps. So look for a report after Thanksgiving and have a good and safe holiday and be very grateful.

Norman

[Floor]

 

   give us a good description, when you have the time ?

      floor

[norman6538]

From previous ignored posts. Butch Lafonte taught us that a moving magnet will roll easily on metal if kept equidistant - nothing special but
1. by exploiting this you can escape from one piece of metal to another over a small gap.
2. Then by arranging the the metals as "ramps" when the magnet above slides from the high end of the ramp to the low end the metal will lift up giving more work out than in
3. the sticky spot is then ignored by moving the magnet back where it started from
4. but better than that is easily move that magnet  past the sticky spot on to the top of the second ramp removing the lost work in to reset back to the top of the first ramp.

Those skilled in the arts will know what to do next.

Hint - that means start at the bench....

Plus I have a few enhancements hidden in my pocket.
Norman

[norman6538]

Over the weekend I was able to make another setup with 3 ramps and they performed well. The concept is solid. So now the real challenge is how to use the excess power.

Happy Thanksgiving to all.

Norman

[norman6538]

Major success today. I have found a way to use closer stronger and escape giving 440% or more OU. Except for some enhancements its all explained in this forum.
Again I have to give credit for Butch Lafonte for his ideas that lead to this success. I just wish I knew what happened to him.

Norman