Lords of the Ring

[Rosphere]

Mylords,

... with a top half inner coil and a bottom half inner coil.  One to catch the electrons in one direction and the other in the other ...

Just stumbled over that.
This somhow coincides with what I want to convey:
I think care should be taken to avoid cancellation of the currents.
This will be difficult with a 100% symmetrical setup.

Is this why the effects of Otto's distorted mess ;-)
have not be replicated as yet?
If you take a look at the first photo in his thread again
Otto`s replication of Steven Mark`s TPU
and take note of how the lampwire cuts through his control coil...
Is everybody trying to build too symmetrical? so that the yellow electron flow which takes off so nicely into two opposing directions in Rosphere's avatar, in the end cancels itself out?

Just thinking out loud.

Trust me, put down the beer and finish reading Ronotte's document. 

You mention my avatar, which I just switched back to the Saturn Socket this morning.  So, I will switch it back now, for a while.

[bob.rennips]

http://magnetism.fateback.com/Overunity.htm

Thanks Grumpy.

Extracting the good idea from the rubbish in the above paper...... we have NMR of copper may play a part in the operation of the TPU.

70% of copper is of one isotope.

The NMR of this isotope is 26.515441 Mhz (megahertz) relative to hydrogen.
As hydrogen has an NMR or 100MHz, this means the absolute NMR for copper is 126.515441 MHz.

If this is not the way of getting the absolute NMR from the relative NMR please shout up.

An interesting experiment would be set up a copper coil that resonates at 126.515441 MHz and see what can be picked up either by a wire running through the coil (i.e. as a collector) or a separate coil placed at right angle to the resonating coil. At this point I'm not suggesting these coils are connected together. This is an experiment to see if pulsing a coil at the NMR frequency, where the coil also resonates at that same frequency, will generate any anomalous voltage/current measurements, in another coil or wire at different placements around the pulsed coil.

126+ MHz is obviously a high frequency to generate in a home lab setting, my function generator and scope only go up to 3MHz. Other lower frequencies that could be useful are those that are common factors of the above frequency. The common factors are:

13 Hz
1439 Hz
6763 Hz ***
18707Hz (1.87 kHz)
87919Hz (87.919 kHz)
9731957 Hz (9.731957 MHz)

6763Hz looks like an interesting first frequency to try.

[innovation_station]

a question if i can



who has finished the game ?

play the game to understand!!

.

[Rosphere]

 

[giantkiller]

Somebody is going to burn something up. It is inevitable. Should a cash prize for offered for stumbling? How does one explain 'Playing Doctor Frankenstein' to the insurance company in a suburban environment? Is one covered in the act of TPUing under the influence? Ahem, Rosphere?
I can see the news now: Citizen levels house with $10.00s worth of items procured from local electronics store while inebriated. What was he drinking? Pale ale, wheat beer, lite beer? There will be a mad dash to the liquor stores. Bottles or cans? Didn't somebody say aluminum? Do they even make copper cans? I saw somebody sliced the cans with wire. That's it! I need to drink the whole six pack now to get enough metal. No, I think I'll get a keg and wrap copper tubing around it! I'll call it the Keg Power Unit! Does overunity equate to free beer?

That is a party with free firewoks! Who is going to be the first person who puts the first unmanned keg on the Moon?

--giantkiller. That should get somebody's attention.