Magnetic flux motor just patented that creates it's own electricity!

[Ufopolitics]

If the 'gain of torque' is so high, why doesn't he put a generator at the output which could power the input motor ?

This would be a 'proof of concept'.  Torque measurements are not.

Exactly...agree.(That is what I have written on my previous post)

[e2matrix]

He might be aware that anything claiming free energy without any external input or fuel often (always?) attracts the wrong attention and is made to disappear, get shelved or the inventor 'dies suddenly'. 


I think a heavy flywheel could help prevent sudden load slip... 


I won't discount this device as fake until proven as such.   I do think it might be good to contact him privately to talk about a looped device test.  Maybe he has already done that or might be open to it ... privately.

[am1ll3r]

I think the disk break shown prevents the "hammering effect"

https://youtu.be/_gGLN2LxwkY?t=190

I imagine if it didn't have that it would jump or slip out of sequence.

[synchro1]

The chief enemy of this design is core saturation.  High perm materials can help reduce the hysterisis loop but the losses make this kind of generator extremely inefficient over prolonged run time. He says "The rotor begins to jump ahead"! This is because the stator is magnetized and chasing the rotor. Kickback! The ordinary result of saturation.

[Ufopolitics]

I think the disk break shown prevents the "hammering effect"

https://youtu.be/_gGLN2LxwkY?t=190

I imagine if it didn't have that it would jump or slip out of sequence.

Negative, the disc and caliper is just to add a mechanical load, by putting some hydraulic pressure on disc brake pads through caliper pistons, it will add more friction to output shaft. Not necessarily fully stopping it.
The hammering effect would be there at all times, by armature following the director input shaft to next step or jump.


Ufopolitics