Chas Campbell free power motor

[ashtweth_nihilisti]

Stefan, ill do my best, i don't want to push him too hard, he will show us when he is ready he made that quiet clear to me

Also that wheel there is for show he told me, (last night).
His new system wont have elements of either systems

[tao]

He says that he channels back 25% of the output energy and that this keeps the unit perpetually moving, ie. perpetual motion.

So the question is, If the alternator is run only via the gravity motor, like he says, what is that 25% of electrical energy used to do? Why does any electrical energy need to be cycled back?

Unless, he uses some of that energy to bypass a 'locking/sticky point' in his gravity motor.

Did he tell you anything about that Ashtweth?

[kames]

He says that he channels back 25% of the output energy and that this keeps the unit perpetually moving, ie. perpetual motion.

So the question is, If the alternator is run only via the gravity motor, like he says, what is that 25% of electrical energy used to do? Why does any electrical energy need to be cycled back?

Unless, he uses some of that energy to bypass a 'locking/sticky point' in his gravity motor.

Did he tell you anything about that Ashtweth?

@tao

To channel some energy back is needed to smooth the operation and increase the performance and also maybe to avoid some sticky points. If there is an excess of energy, why not to feed some of it back even for a simple reason as for a better performance and smoother operation?
Think simple.

Kames.

[Aphasiac]

@ Ash:

Should you maybe try to convince him to compile details of his design and attach it to his Will with instructions for its release to the public domain? ... just--you know--as a precautionary measure for the interim?

You've obviously established some level of rapport with him by this point, so you would know best what to do. This is just a suggestion.

Great work, by the way! 

Mark.

[ashtweth_nihilisti]

Guys, i know the obvious, i represent a non profit org that deals with open source, we have put the details on the site.

We are doing our best to get as much information as possible