Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Scope shots of clean kicks

Started by bob.rennips, June 26, 2007, 11:07:47 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

bob.rennips


and there is MORE...


With a bifilar and two pulsers both pulsers set up with diodes you can pulse the electric field. The voltage rises substantially with each pulse. This is not the same effect as step charging a capacitor as in a camara flash. This proves we will be able to rotate this electric only field at high speed.

There are lots of possibilities here. What happens if you can set up a rotating electric field and on top of this field pulse it at 7.8 Hz, the schumann resonance ?  I reckon you'll get some major entrainment of the ionesphere energy happening. BOOM.

This would also explain why it's so hard to control. The schumann resonance changes by +-0.5 hertz over the course of a day. During solar storms the schumann resonance can change very rapidly. You can set it off frequency and as the schumann changes it'll drift by the exact tuned frequency of your device and BOOM! (Another SM tick)



bob.rennips

I think the follow shot is of a diode in the 6 inch tpu.

bob.rennips

 Following a questions from Earl.

The coil is connected: 12volts to diode to coil to diode to mosfet to earth.

The voltage level is frequency dependant.

It hunts up and down as you sweep the frequency so obviously a resonant effect. If you lower the repetition rate to around 100Hz it drops in a decay curve down to about 30V. From 5khz and above it looks to be dead straight even on a x10 mag of the timebase. There is obviously an ongoing leakage of the electric field.

I checked again shorting a coil at 90 degrees to this coil does not extract the energy - so my bad on that point. In a bifilar situation shorting the other coil does extract the energy.

I think at the higher pulse rates this electric field can still be utilised to create a rotating electric field.


Bruce_TPU

Hi Bob.R 

Good experiments!  And that is what we need.  especially from those of you with the know how.

Hey, I found this tid bit from Tesla about a rotating magnet field on a toroid.  Is there a way to employ this bit into our experiments?

Plate 3  THE SQUIRREL CAGE ROTOR UNDER THE ACTION OF THE ROTATING FIELD.

The wound stator ring described above can serve to demonstrate Tesla's Egg Experiment.  A sheet of non-metallic material is placed over the windings on the stator ring; a metallic egg is placed on this sheet immediately revolves around its minor axis as soon as the windings are energised from a three-phase supply.  As the speed of the egg increases the egg rises on one end and continues to spin about its major axis, thus maintaining a vertical position without additional support.

Happy Days!  :)
Bruce
1.  Lindsay's Stack TPU Posted Picture.  All Wound CCW  Collectors three turns and HORIZONTAL, not vertical.

2.  3 Tube amps, sending three frequency's, each having two signals, one in-phase & one inverted 180 deg, opposing signals in each collector (via control wires). 

3.  Collector is Magnetic Loop Antenna, made of lamp chord wire, wound flat.  Inside loop is antenna, outside loop is for output.  First collector is tuned via tuned tank, to the fundamental.  Second collector is tuned tank to the second harmonic (component).  Third collector is tuned tank to the third harmonic (component)  Frequency is determined by taking the circumference frequency, reducing the size by .88 inches.  Divide this frequency by 1000, and you have your second harmonic.  Divide this by 2 and you have your fundamental.  Multiply that by 3 and you have your third harmonic component.  Tune the collectors to each of these.  Input the fundamental and two modulation frequencies, made to create replicas of the fundamental, second harmonic and the third.

4.  The three frequency's circulating in the collectors, both in phase and inverted, begin to create hundreds of thousands of created frequency's, via intermodulation, that subtract to the fundamental and its harmonics.  This is called "Catalyst".

5.  The three AC PURE sine signals, travel through the amplification stage, Nonlinear, producing the second harmonic and third.  (distortion)

6.  These signals then travel the control coils, are rectified by a full wave bridge, and then sent into the output outer loop as all positive pulsed DC.  This then becomes the output and "collects" the current.

P.S.  The Kicks are harmonic distortion with passive intermodulation.  Can't see it without a spectrum analyzer, normally unless trained to see it on a scope.

Jdo300

Quote from: btentzer on July 01, 2007, 10:18:13 AM
Hi Bob.R 

Good experiments!  And that is what we need.  especially from those of you with the know how.

Hey, I found this tid bit from Tesla about a rotating magnet field on a toroid.  Is there a way to employ this bit into our experiments?

Plate 3  THE SQUIRREL CAGE ROTOR UNDER THE ACTION OF THE ROTATING FIELD.

The wound stator ring described above can serve to demonstrate Tesla's Egg Experiment.  A sheet of non-metallic material is placed over the windings on the stator ring; a metallic egg is placed on this sheet immediately revolves around its minor axis as soon as the windings are energised from a three-phase supply.  As the speed of the egg increases the egg rises on one end and continues to spin about its major axis, thus maintaining a vertical position without additional support.

Happy Days!  :)
Bruce


You mean this?

http://www.youtube.com/watch?v=brNBVDCeECg

God Bless,
Jason O