Selfrunning cold electricity circuit from Dr.Stiffler

[bolt]

Anyway i haven't been around much lately although i stop by sometimes to catch up on the gossip. I was hoping to have the resources to do this myself but this Dr Stifler experiments are closely coupled to the TPU. I will spill the beans on some of my ideas i really do hope some of you will look into this closely.

The heart of the TPU is the ferrite core i suspected this for many weeks now. As stated in my other posts the frequency of operation is up around the 1 to 2 megs range depending on the ferrite ring and windings. However this is the catalyst and is common on most if not all the TPUs. You will notice from the Stifler experiments that the power of the LED's is brightest at a reasonce frequency and the performace is directly related to the Q of the coil.  One of the fundamental breakthroughs i see is realizing that the coil is self oscillating and as SM said the entire oscialltion is directly proportional to the TPU size. These small experiments are definntiyl heading the right way i am sure but you can increase the Q of the coil but an old trick which SM has hinted at before by using super regen radio and self quenching circuit. This is dead easy to do basically another resistor and cap on the emiiter which has RC =t 5kHz. Qunching allows the oscillation of the 1 meg coil to expand which drives the quench to on. The 1 meg osc field collapses and the RC discharges at 5k. The effect is the coil now has a tuned gain of  about a MILLION!

You may think this odd but SM states the TPU is similar in operation to a radio and the TPU all exhibit a 5k hash which is directly as a result of using a oscillator which is quenched at 5k!!

The output will then be DC with a 5k hash component but it all starts at the ferrite core and the other coils perpetuate the feedback by passing a winding through the ferrite ring. This is how you get feedback of a TPU. Now you see that we are dealing with pure sine of the self oscillating ferrite ring which is harmonized to the larger TPU coils and the circuit had nothing to do with whacking it with square waves.  When you get this right the output should be cold electricity DC with the 5k hash of the quenching circuit which explains why the circuit is so damn small and simple it can be shrunk inside of a tiny TPU. Further more to expanding this idea i believe the TPU is based upon a tube layout comprising of three parts thus you MUST have 3 coils and a ferrite ring.

In essence its an amplifier of positive feedback. One coil of the TPU is the cathode the next coil is the anode and the ferrite ring is the grid which is oscillating is our third coil which may or may not be connected to a grid coil but highly likely it was on the large TPU's. Now we apply a small DC voltage between the cathode coil and the Anode. Nothing much happens till our grid coil which is running from the ferrite ring oscillator is producing the 1 meg gate signal quenched at 5k sits on the middle coil but its closer to the cathode just like a tube amplifier. The electrons passing between our cathode towards the anode are now excited by the grid control and race towards the anode. Yes this does work without a heater when in resonance! Because the ferrite core has been amplified by a MIO the grid is supplying cold electrons which are now stacking up on  our anode coil. This is why the large TPU is quite a high beast as it has 3 coils with grid and cathode coil near the base and the further we can get the anode as a ratio between the grid to cathode to anode ratio the better it will amplify.

We simply take a winding and pass it from the anode coil back through the ferrite ring which is our grid to give us positive feedback! The circuit is now explosive because the cold energy is going between the cathode coil to anode and is modulated by the grid signal...our ferrite. Because the ferrite is not part of the feedback loop par se then it does not have to support the real power generated between the coils which means the grid oscillator should run on 5 mA and the power output is whatever the coils will support without burning up.   

i do hope something comes of this soon. GL

[Pirate88179]

I just talked to a friend of mine that works for MIB.  He said, and I quote, "There is no Dr. Stiffler and there never was a Dr. Stiffler.  I just said....."ok."

Bill

[DrZLowe7]

MIB have told him to bugger off.

Maybe he was bought off by somebody ?

An investor of any large some of money will not invest unless there is very positive proof of getting a return. It was people like EMdevices and me that were telling what he really had that ran him away. The first thing a scam artist will do when exposed is run for the hills. He was criticizing any and every effort tried to check for over unity saying that it will not work.  Which brings up the question if you can not test by normal means then how can he claim OU. Since there is no way to test according to him.
As EMdevices and myself have shown nothing new no mystery.
As far as MIB I am sure the government with there real scientists looking at what he was doing were not impressed.
Again run your car using water with my secret ingredient absolutely FREE for $25.00 shipping. No scam!!!!!!!!

[c0mster]

 

[bolt]

I think you ruined it. We only had to wait for Dr Stifler Youtube vid number 10 next week to see 100 LEDS running all by themselves with no cables or batteries attached anywhere:)

Now we are back to the dark ages.