ufo/space ship blue prints

[Pirate88179]

You mean this design by Hans?

Bill

[z.monkey]

   Cool! when is the prototype going to be available.
I'll send you a purchase order...

[Cap-Z-ro]

Yes, thats the one...thanks Bill.

*heads off to bathroom to conduct fuel tests*

[Koen1]

LMAO
Thanks for that one Bill!

B0rg, you may want to look up David Hamels flying saucer design?
what was the story again... oh, right:
Hamel was contacted (telepathically?) by aliens, who taught and showed
him things about how their craft worked. Being a carpenter with zero
physics training besides how to use a saw and hammer, Hamel started experimenting
by himself. The aliens had apparently shown him how all their technology is
"self-powered" based on magnet-powered perpetual motion, and Hamel
built a number of devices that have been studied by many, among which the
so-called "Hamel spinner" a.k.a. "spinning magnetic top" a.k.a. "spinning top",
and the "3 cone device" a.k.a. "45 gallon drum device"...
These devices were built by Hamel to better understand the technology,
and to make sure that he could build the permanent magnet powered flying
saucer engine correctly in one go.
He finally build the engine, a "45 gallon drum" prototype of which was claimed
to have developed such power that it ripped itself free from the floor to which
it had been bolted down, and shot off straight through his roof never to be seen again.
After the engine parts were built and it was nearly put together, Hamel and his
helpers started work on the saucer itself.
Last I heard they were still building the hull, then everything went quiet and
it is said Hamel passed away...