Bessler Wheel Theory by Alex

[hartiberlin]

I will wait now for Alex to let us know,
if his build will behave differently than my simulations.
I believe it not.
It will also keel and will not run in my opinion.

First we have to find a way, that the CoM will alsways shift to
the right ( for clockwise rotation) and never move down inside the wheel,
even better have to move up.

Well Alex, now it is your turn with your build.

Regards, Stefan.

[AB Hammer]

Greetings Stefan

That avi is just what allot of us who have built wheels have seen all to often. 

[Alexioco]

Very nice wheels, shame they didnt work the same way mine does...
There are subtle differences when building wheels, the ones you have built wont work as the poles dont exeed the liftings weights, just leave me to do it now and we will soon see if the wheel runs, if not then im off for a big study...

edit: I just watched it again and in fact im sorry but they work nothing like mine, thanks for your hard work in simulating these wheel though, You must of worked hard on them, well done

[AB Hammer]

Alex

I looked at the photo again and then looked at the avi. No they are not quite alike, but the effects may be. Of course I hope not, but I see 3 weights in the kill zone before shift, and 2 weights in the upper negative zone above 9:00, and 3 in the positive power zone the descending side. It is not looking good in my eyes. Take the graphs I sent you and over lay on your design Remember that the best power is between 2 and 4 o'clock spinning clockwise. the kill zone is between 5:30 to 9:00 this is due to it's going up hill effect. Some would ask why 5:30 as the start, that is simple, you have lost all power and it is in the shift from positive to negative.

[Alexioco]

Alex

I looked at the photo again and then looked at the avi. No they are not quite alike, but the effects may be. Of course I hope not, but I see 3 weights in the kill zone before shift, and 2 weights in the upper negative zone above 9:00, and 3 in the positive power zone the descending side. It is not looking good in my eyes. Take the graphs I sent you and over lay on your design Remember that the best power is between 2 and 4 o'clock spinning clockwise. the kill zone is between 5:30 to 9:00 this is due to it's going up hill effect. Some would ask why 5:30 as the start, that is simple, you have lost all power and it is in the shift from positive to negative.

That?s why I hope the weights that extend upwards will help; also, the weights that extend upwards are heavier.
I have learned with any perpetual wheel that there a re always two more weights on the ascending side than there is on the descending side, its always 2 more weights or if its a bad design then maybe more... if this stops my wheel even with the rods having heavier weights then I/we need to find out how to reduce the weights on the ascending side, if you can?t get any less than two then momentum, excess weight is very important and even centrifugal force...

I need to find out why two more weights are always on the ascending side, there as to be a way to beat this which in itself would be perpetual if achieved...
If my wheel does not work then I will have learnt that width cannot be used to achieve height, unless Bessler did it that way in a strange way, you see, really he must of as my wheels come purely from his MT's...