PULSE GENERATOR SPECIFICS

[Jokker]

Farlander ... seems that u are setting up big plans.
There are no1 who archived something u want to ... but there are very few of them who are getting some results.


U need to know much about this thing... whole theory behind it and so on.

If u are looking for very accurate pulsing signal ... then it is pretty hard to get.

I can make a pulsing circuit with gate time and increasing pulse amplitudes. But it is only driving part of it... so it need to be amplified. If ur so sure that low currents will work then its tricky, coz if low current will not work it will be just useless and expensive.
To get pulsing circuit far more effective u need to use switching elements like transistors...They need to be very fast recovery and hight power.   But yea ... i got no idea how to build it up by using switching elements to achieve increasing amplitude.     

[gazzzwp]

Farlander

I put the Dave Lawton circuit together today and it's almost complete.  I still have the cell to make yet, so I dont anticipate getting gas for a couple of weeks yet.

My circuit is exactly like the one on page 7 of D14 (October 2007 version).  No alternator, but I am using a bifilar wound choke - my ferrite rod is 3" long and I could only achieve 50 turns on it with 22swg enamelled wire- not the 100 recommended in D14 however I wound another one so I can use 2 in series if required.

My 12vdc psu is on order, and I am also looking for a cheap oscilloscope (pc or otherwise) so that I can set the thing up before attaching the cell.

I could send you a photo of the circit board if you wish  just email me at gazzzwp@yahoo.co.uk

Gazza

[NRAULJI]

Hi !

Pls. buy one from www.aquapulser.com.
The PWM specs are :

Input : 12VDC
Output : 12VDC, 6 Amp max.
Freq. : upto 500 KHz

There are several controls for fine tuning.i.e Freq, Range and Mark/Space each for Oscillator and Gating.

I am sure this will help you a lot with your project/ experiments as it aimed at the researcher community.

If you have any query, pls. let me know.

Nitin Raulji
3witech@gmail.com

[pese]

Hi !

Pls. buy one from www.aquapulser.com.
The PWM specs are :

Input : 12VDC
Output : 12VDC, 6 Amp max.
Freq. : upto 500 KHz

There are several controls for fine tuning.i.e Freq, Range and Mark/Space each for Oscillator and Gating.

I am sure this will help you a lot with your project/ experiments as it aimed at the researcher community.

If you have any query, pls. let me know.

Nitin Raulji
3witech@gmail.com

Can anybody tryto use PEM control from 12 Volt batterydrill machines (fro scrap=
i use this for a lot of other appliations.  Possibly with np "regu?ar" Load (water , like ancell)
youmust use als an Load resistor (2  to 5 ohms ?)  I use instead car bulbs (lamps) 20 or 50 watts.  Try it and give an not fot(un)sucess.

G.Pese

[Jokker]

Anyway have someone seen some efficiency increments by using pulsed voltage? Videos on youtube tells that it is increasing efficiency by 2 ... 5 %  . But there are many ppl who tells that it will make your car run 100 % on water, but they are also tease ppl who are selling stuff like pulsing circuits. Sounds tricky 

http://hydrostarcar.com/forum/