Howard Johnson Replication Tube Claim

[lostcauses10x]

I wish to express my gratitude to Mylow for bringing this to our attention. It is always refreshing to think out of the box even if it breaks the status quo. Interesting regardless if it works or not

We all know we need independant verification before jumping up and down like locos , We cannot meaningfully replicate without knowing exactly how the magnets are performing , i.e a full B-H curve of both stator and rotor magnets. Their proximities, the temperature at the time the rig was running, The velocity of the edge of the rotor, The MOI of the rotor. Also including Aluminium in anything magnetic is generally regarded as a Big no, no. Would replacing the rotor with perspex or other material add to , or hinder the effect? 

I find it hard to believe that the Ali crossbarr is enhancing the effect, (Sounds like a judson damper to me) Any form of braking, which is what will happen when you have that many horse shoe magnets wiz pass the crossbar cannot help be reduce overall efficientcy. But perhaps i am wrong , and the braking in some strange way is helping the magnetic materials recover after each transaction. I don´t suppose i will know until this is published in some journal or other. ( assuming its valid)

It would be nice to get such information, yet I doubt we will. Equipment and knowledge to use such is usually just not available.

Who know what the aluminum content is of the disk, much less the what appears to be an old arbor for the bearing housing and plate mount.  Simply a lot of unknowns with this one.

Surplus magnets again in which are an unknown, and so on.

[CLaNZeR]

We cannot meaningfully replicate without knowing exactly how the magnets are performing , i.e a full B-H curve of both stator and rotor magnets. Their proximities, the temperature at the time the rig was running, The velocity of the edge of the rotor, The MOI of the rotor. Also including Aluminium in anything magnetic is generally regarded as a Big no, no. Would replacing the rotor with perspex or other material add to , or hinder the effect? 

Totally agree with you Craigy.

Mylow has produced more information in his collection of videos than any other thing we have tried to replicate over the years.

This is a huge difference that people are not recognising. Usually we get One or Two videos at the most and they vanish. Is this because of the abuse they get bombarded with or because it was a fake? who knows.

But Mylow is sticking around, he has had his doughts and his scares as we can see by the deleting of the videos and then the re-appearing.

So maybe the next step is to encourage him to measure the Flux of the different magnets, weigh everything and produce figures like the MOI. If he does not understand how to do these things, maybe he is open to learning them. I am sure if any of us found something like this, we would be more than happy to learn these things to get the information out there.

Be interesting to see if his new modifications of replacing the 2" cross bar with a skinny setup effects anything etc etc.

[Craigy]

Thats unfair..to x 000013

[Reiyuki]

X00013:
The aluminum disk is unknown alloy, but many machinists like to work with 4000 and 6000 series alloys because it cuts very well.
The bracket is most likely 300 grade as it is what Home Depot and Lowes use.

[rlortie]

Hope ur right. Liar I am not, Idiot maybe, Mylow had it backwords like his poles.

I would rather be called a liar than an idiot, one I can possibly substantiate, the other is questionable by being involved in pursuing over-unity to start with!

Ralph