Wind Turbine Competitor Steps in well maybe? Enter Wind Pipe

[FreeEnergy]

UPDATE:

Got the acrylic rods in the mail today along with the mags holy talk about cool it preforms as expected with bounce ...

Should be in for an interesting project!

very cool indeed!

keep us updated. post pics/vids.

peace

[infringer]

I really need to purchase a video camera... Any suggestions on a cheaper but worthy High Definition Camcorder that supports SDHC 32GB and records to x264... Only thing I can think of is the flip but that is only 720P I'd prefer 1080...

Truth be told the better the source the better the encode.

I finally split apart all my mags the other day during testing when I repacked them they all stuck together good thing I had a metal shelf with thin bars press real hard at the between they will both split and be stuck to each side of the thin metal bar then you slide one up the bar and pull it off set it a safe distance away and then take the remaining mag off the other side of the bar ... I was stuck for an hour trying to figure on how to part them all again.

Little tip for handling magnets"

[infringer]

SIDE NOTE:

The base of this unit looks big I am starting to wonder if the axial flux generation method is not used here... By that I mean two sets of mags and coils in the middle it looks almost as if the mags could fit in the bottom ... Just a side note to myself so I don't forget the possibility.

[infringer]

Going to purchase parts today...

PVC for coil winding and PVC for device...

Magnet diameter is 1"

PVC for coil winding 1 1/4" OD

PVC for housing coils and mags 1 1/2" for starters maybe a bit smaller 1 3/8 or 1 7/16 ID may prove more useful ...

PVC T  splitter and a joint for connection with a cap.

Rubber cement.

Black glossy spray paint.

[infringer]

EDIT NOT APPLICABLE!