Ibpointless2 Crystal Cells

[triffid]

That conductive glue looks good too!Thanks for the link!triffid

[stprue]

No problem.

I have been meaning to coat a small piece of paper with this glue and then use that as insulation between copper pipe and magnesium ribbon but have not gotten around to it yet.  It may short or may act as a more efficient dielectric.

[triffid]

I tested my second JT output with the AC side of my voltmeter as someone here recommended and saw 2.7 volts coming out of it.Its powered by a 1.5 volt DC battery.Next week I order my conductive string.I figure its soft enough to tie to pencil leads.My last six cells made about 6/6 have good and strong magnesium strips in them.I did not have anything in there to weaken the magnesium.I did have alum and Epsom salts mixed together.I want to wire some flint rocks together to see if I can add up the voltages.


In further testing of my two storebought diodes I get voltages ranging from .008 volts to .010 volts when they are hooked up in series to each other.Once again the voltages are highest in a N-S position.


I also plan to grow a crystal with two electrodes sticking out of it.


I did not get a new camera phone.I'm saving 20 dollars a month on the phone bill by knocking off the internet section of my phone plan.
triffid

[triffid]

So 100 diodes of this type would give me 1.0 volts.Hooked up in series that is.Good thing electronic scrap is everywhere.triffid

[stprue]

What type of diodes are you using?