another small breakthrough on our NERD technology.

[AbbaRue]

This fellows measurements shown on the following video show a substantial amount of power from
the signal generator is bypassing the MOSFETS and getting to the heater load. 
In fact once the power from the battery is connected the power entering the Heater load actually drops drastically. 
http://www.youtube.com/watch?v=HK9TNFuvM2k&feature=autoshare 

[Magluvin]

Seamonkeys are cool.   

Mags

[poynt99]

Rose,

I have what I think are a good couple of ideas:

1) Open source this testing. Meaning? Get a number of folks involved, even if they can not be there to witness the tests. A few members here from OU (Wilby, Mags, Gyuala, Stefan perhaps), a few from OUR, and a few of your folks. We hammer out an acceptable test protocol and decision factors we are all happy with.

2) There is a much easier, cheaper and quicker way to settle the COP question. And if all agreed, I would be willing to consult with Stefan, Steven Jones, and the contributors to the OUR Award to seriously consider this as a "GO" test for the prizes. No academics required. I would like to have an electrical engineer there to be a non-biased judge/observer of the test to verify the outcome. This could be a hired professional from the Cape Town area.

The method I propose is the dual light bulb idea I described some time back. Two power diodes and two 60W or 100W light bulbs are placed in series with the positive lead from the batteries. I would suggest as a prerequisite, you confirm first that with these diodes and bulbs installed, the apparatus still exhibits the same or similar infinite COP measurement you are seeing now. I would strongly suggest too that the two light bulbs be fully covered with a cardboard box for this prerequisite test.

Once you have confirmed that your measurement is still COP infinity, then the clearly labeled bulbs can be revealed and it should be immediately evident which direction the greatest current is passing, i.e. either from the battery (underunity), or to the battery (COP infinity).

What are your thoughts?

.99

[Magluvin]

This fellows measurements shown on the following video show a substantial amount of power from
the signal generator is bypassing the MOSFETS and getting to the heater load. 
In fact once the power from the battery is connected the power entering the Heater load actually drops drastically. 
http://www.youtube.com/watch?v=HK9TNFuvM2k&feature=autoshare

Question....

So, the "waveform" is larger without the battery?  What is that trace connected to or across to get that top waveform?   And without the battery in the circuit, look at the schematic in the vid, There can be no current flowing in the load if the battery is out of the circuit. Thus NO power getting to the load without the battery in the circuit.

Now, think about this. The loop in the circuit is open when the battery is disconnected. I didnt see any jumper put in to close the loop so current can flow into the load.  The load is only connected by 1 lead, because the battery is out of the circuit. So if the battery is disconnected, and the waveform is huge, that is because the rest of the circuit is out of the circuit. There is no load on the gen. thus a huge wave form. All because the battery is not in the circuit.

But what does that show us?

That is, if the circuit shown in the vid is what is on the table.

Mags

[Magluvin]

10v from the generator, into 3v of AA. Would that draw some current from the gen?  Load it down any? 

lets see, 6 12v batteries=3v AA .      If you were to use 6 12v batteries, just round it off to 72v, what would you be setting your gen voltage to then? 237v?

Mags