Re-Inventing The Wheel-Part1-Clemente_Figuera-THE INFINITE ENERGY MACHINE

[ourbobby]

Hi marathonman,
                          My apologies! I read too much sometimes trying to catch up or cover the ground or look for clues. You are correct to correct me. Part G is what it will be. I have come across a good youtube video by UFO on the part G. It would seem my analysis of getting that going is the first option of the build is the correct decision.


The interest in the ampere turns is to avoid saturation of the coils and get the generator running efficiently! Thanks for the heads up on the calculation.


regards


ourbobby

[ourbobby]

Hi marathonman,
                         Last comment before I go to bed. i am unable to get the big powdered iron toroid that you can. However, i can get Hollow Bar in various sizez and thicknesses. I have the cores, but, this sie is not related to Part G. What would be a good size? Something like 160mmOD - 100mmID nd height say 100 mm.
I have to order and get it cut and delivered. So i have lots of flexibility. Also, Hollow bar can be decarbonised!


Regards


ourbobby

[ourbobby]

Hi marathonman,
                          Proving more difficult than I thought to get small piece of hollow bar! Anyway, I have found a small piece locally in the scrap heap at an engineers shop. It is 160 diameter, 87 Inside diameter and 55 high. As we are talking inductance, might this be a bit small? Although i could use a smaller guage of wire perhaps?


Regards


ourbobby

[forest]

I have the feeling Figuera was in the same situation as we today and he just found a way to modify the existing motor or generator

[ourbobby]

I have the feeling Figuera was in the same situation as we today and he just found a way to modify the existing motor or generator

Hi Forest,
              I think he did more than that. Anyway, I am a bit weak on some of the calculations for inductance and various phase changes. Some people see these more easily than others. Thanks for the comment.


regards


ourbobby