Single circuits generate nuclear reactions

[AbbaRue]

I finally found the pulse circuit I needed.
It's a very simple circuit, the 3uF capacitor sets the pulse width,
and can be replaced to get different pulse widths.
The 50 V on the diagram would be your capacitor bank.
The 100 ohm resistor is were the carbon rod goes and the switch is the pushbutton.
No matter how long you hold down the switch only one pulse goes to the rod
until you release it, and push it again.  This is exactly what I needed,
Tansistors are cheap 2N5551 NPN's, any NPN should work.
To modify it or check out pulse width values, it's one of the circuits found in the transistor
section of the circuit applet I mentioned earlier: Monostable Multivibrator under Multivibrators.
How ironic, it was under my nose the whole time, I use that applet to test everything and didn't see it.

[Elisha]

@ UncleFester, Allcanadian, leo48, miki and twosox, Keep the good work !!

For make a circuit diagram, please use an ease to use and free (for less that 500 pins, small circuit) software, DesignWorks Express, http://www.capilano.com/downloads/windows/DesignWorksExpressSetup.exe

For ease reading and sharing of circuits.

registration is free, and have all the library that we need for this circuit including the 555 chip.

[leo48]

Preparations continue!
I hope next week to start.
Hello to all
leo48

[Elisha]

Here is the first review to the circuit of Abbarue. each part of the circuit have a part name to better indicate the changes needed.

I change the 100 ohm resistor for 1,8 ohm resistor, this is the real value for a little piece of carbon.

included the strong neo magnet

included the toroidal to extract the electricity generated.

Please make any review to the circuit, i will make the changes.

http://cid-af6651c3ee69b115.skydrive.live.com/self.aspx/Varios/SingleShootV01.cct

[UncleFester]

Preparations continue!
I hope next week to start.
Hello to all
leo48

Looks good Leo! I am waiting for more parts and will test next weekend.

Keep it going!