Stivep1: Tesla Rehash (Akula device)

[br549]

I can't speak for anyone else, but personally I would be ecstatic to obtain excess energy from a device, with or with out a ground.

[baroutologos]

I also used enameled wire (#25.5 awg) to wind a coil for testing. The below attachment shows my preliminary testing, which was done with only the bi-filar coil. I was looking at the system drawing on the previous page that shows a magnet coil and a split aluminum tube. By the way they are illustrated, I am assuming that they are below the bi-filar coil. I am thinking that they will reduce the resonant frequency, but not sure until I build and test. The magnet coil rings a bell in reference to Kapandze device. I remember reading an interview, and being ask, 'what would happen if the ground was disconnected while the device was operating'. He said that it had happened once, and caused damage to the magnet coil?

Hello br549,


Those relative slow resonant frequencies of the biffilar coil tested results from having the coil (biffilar) shorted to itself or just being ends open or one open other grounded?

[br549]

Wesley:
Thank you so much for the video information, very informitive.

Baroutologos:
Below is the setup I used for my test coil.

As Always; Thank you and have a great day;
br549

[baroutologos]

@Br549,


Thanks for the detailed info of your setup. So as far i understand, the 27 Khz resonance frequency of the tri-layer "biffilar" is with one end grounded and the other open (connected to probe of spectrum analyzer that is practically open)


Any idea about the inductance of that coil? Have you calculated that? I guess LC meter may not give correct figures due to internal capacitance. Any special observation so far?
Thanks

[br549]

@Br549,


Thanks for the detailed info of your setup. So as far i understand, the 27 Khz resonance frequency of the tri-layer "biffilar" is with one end grounded and the other open (connected to probe of spectrum analyzer that is practically open)
Any idea about the inductance of that coil? Have you calculated that? I guess LC meter may not give correct figures due to internal capacitance. Any special observation so far?
Thanks

baroutologos;
The total inductance of the coil (connected in the bifilar configurration) is 30.7 mh. The waveforms (coil performance) seems to be similar to what is shown in the videos.

I was trying to get a better understanding of the Transmitter and Reciever Controller Circuits. Do you know what the KT555TB9 Chip is, and if there is an english (or translated) version of the spec sheet?
As Always; Thank you and have a great day.
br549