Closing the loop on Milkovic's two-stage mechanical oscillator?

[ltseung888]

The Milkovic lever pendulum type pendulum as shown in the above quoted youtube video can be considered as having the following:
1.    A simple pendulum to accept input.
2.    A lever system to convert the swinging energy into lifting a weight.
3.    The lifting of the weight occurs only at large angle of swing.
4.    One push of the pendulum corresponds to twice lifting of the weight.
5.    The Output energy can be determined accurately by the total height of the weight times the mass of the weight times g. (The total potential energy or work done in lifting the weight.)
Output Energy = mgh
6.    The Input energy can be determined accurately by replacing the pendulum bob with a magnet with the S pole facing RHS.  A solenoid or electromagnet driven by pulsed direct current can be used to generate repulsion. There can be a sensor mechanism to determine the start of the pulse.  The pulse duration can be adjusted.  The Input Energy can be determined accurately via an oscilloscope via integrating the Voltage and Current of the Pulse.
7.    Note that the experiment must be done at large angles when the weight is actually lifted.

Most of the loopback attempts do NOT satisfy point 7.  Failure is expected.....

This particular experiment simplifies the overunity determination as it eliminates the losses and mechanical complications.
Some experimenters who already built similar devices can modify to test the above 7 points.

Divine Revelation?

7.    Note that the experiment must be done at large angles when the weight is actually lifted.
In Physics, work is done (energy is spent) only when there is displacement.  With the many looped mechanisms shown on the Internet, the experimenters missed that point totally.  So far, I have not seen a single experiment that used the large angle with actual lifting of the weight.  If the experiments were done with small angles without lifting the weight, no OUTPUT work was done.  No overunity effect can be seen.
The main thread is too long.  Can someone familiar with that thread comment on this "new insight"?

Divine Revelation?

[ltseung888]

In analyzing the Milkovic 2 stage pendulum as shown on youtube:
https://www.youtube.com/watch?v=gC6Qlj1Mbo8

We noted that after 2.30 minutes, a single push by the hand will lift the weight twice.  On close examination, the lifting of the Weight appeared to be when the pendulum bob is swinging with the maximum velocity at the vertical position.   

It should now be clear to all experimenters that any overunity measurement or loopback mechanism MUST be done at large angles when the weight is actually lifted.

[markdansie]

Hi 888
no amount of theoretical calculations can replace a simple running device demonstrating a closed loop. It might be better trying to explain the energy cycle.
Kind Regards
Mark