Partnered Output Coils - Free Energy

[EMJunkie]

Post removed. Copyright content issue.

   Chris Sykes
       hyiq.org

[tinman]

Post removed. Copyright content issue.

   Chris Sykes
       hyiq.org

EMJ

You do not have to remove things that relate to something that has a copyright on it. The only thing copyright dose is prevent you from making and profiting from that copyright product. This includes the likes of video's and books-these you cannot post in an open forum.

[EMJunkie]

EMJ

You do not have to remove things that relate to something that has a copyright on it. The only thing copyright dose is prevent you from making and profiting from that copyright product. This includes the likes of video's and books-these you cannot post in an open forum.

Will do you a deal Tinman - I will share some more data. How about you make it so that others out there get a bit more info on the RT?

   Chris Sykes
       hyiq.org

[EMJunkie]

Some years back, I created a thread that lost momentum very fast: Reliable and Flexible Switching System - I have already shared my latest unit, back on page 3: My Current Reliable and Flexible Switching System I have made modifications to my unit since then!

No one was interested. To this day, this is my most important piece of Hardware! I suggest you look into such a unit, build it for your self as I have!

Anyway, the point is: Magnetic Resonance

It is possible to build a System that once the right conditions are met, once bought into Resonance will produce effects that can be tapped by means of an Isolated Winding/s.  Some data: (Some of my notes)

5 Volts Input, Duty is 50%

My resonance Frequency is: 1,208KHz

When in Resonance, it gets very noisy - Before Resonance I use Current, it drops off as I move into Resonance. My meter shows no Current draw, no milliamps

I have a sensing Coil on one leg - Voltage on the Coil goes up showing higher Voltage at resonance as one would expect

Input Voltage becomes nearly Sawtooth, Triangle Wave - but is in-fact Square, H-Bridge Switched DC

There possibly might be some symmetrical arrangement with the Magnets here as on the other Coils I could not get this effect.

I suggest you view my early videos on the Fluxgate Magnetometer:
How and Why - A NASA Info Clip
Flux Gate Magnetometer or Solid state Generator

Please Note: When I say Saturation, I meant Reverse Magnetisation and not Saturation.

These Videos show how to Isolate Input from the Output - No Lenz Law Effects reflected back on the Prime Mover. Also I have attached the document from Floyd Sweet again, Magnetic Resonance.

   Chris Sykes
       hyiq.org

P.S: My notes were rough and quick. Taken only as general notes. Earth is necessary or this does not work. Also my initial Meter was a 3 Digit display, only showing 100's in milliamps. Using a second meter, I measured 22ma.

[EMJunkie]

And so, that is another interesting and effective way to reduce ones Input! The same effect for less than 1 Watt, compared to in the Video, I used approximately: 117 Watts.

   Chris Sykes
       hyiq.org