DeBunk This

[tinman]

How about a thread dedicated to debunking free energy devices,where some members may like to build a replica,and show how it was done?--could be fun.
or if you have a thought on how it was done,then post it here,and we will see if it could have been done that way.

I offer the first device,and this one is pretty tricky.
We see to shaded pole motors-one i assume acts as a prime mover,and the other as a generator. We see only the two motors joined together--no wires,and no sign of a battery. It would have to be one hell of a battery to drive that incandescent  bulb anyway.
Watch carefully,and think hard--how is it done.

https://www.youtube.com/watch?v=NwMos1y1Peo


Brad

[gyulasun]

Hi Brad,

I guess they use an open core transformer under the table fed from the mains and the fields from the open core can close via the motor cores and induce current in the motor coils. (An open core can be say a C core or an E core where the top I core is removed.)

Here is another similar video where the buzz from the open core transformer can be heard, see and hark at video time 1:00 when the guy 'switches' to full rpm:  https://www.youtube.com/watch?v=XDnMODCdhB0 

Addition: when the guy lifts up the motors in your video link, they are already rotating at a high enough speed so that the smaller fields from the open transformer beneath it is able to maintain rotation.

Gyula

[tinman]

Hi Brad,

I guess they use an open core transformer under the table fed from the mains and the fields from the open core can close via the motor cores and induce current in the motor coils. (An open core can be say a C core or an E core where the top I core is removed.)

Here is another similar video where the buzz from the open core transformer can be heard, see and hark at video time 1:00 when the guy 'switches' to full rpm:  https://www.youtube.com/watch?v=XDnMODCdhB0 

Addition: when the guy lifts up the motors in your video link, they are already rotating at a high enough speed so that the smaller fields from the open transformer beneath it is able to maintain rotation.

Gyula

I could relate to that,only that large incandescent bulb still stays brightly lit,even when the two coils of the motors would be at right angles to any transformer beneath the table. It would also have to be one hell of a transformer under the table to transmit that much Em energy.

Brad

[Zeitmaschine]

Hot wire removal by software editor? If done thoroughly, you will never detect it.

What about this one: Tesla Working Scheme #1 or that one: Tesla Working Scheme #2

The bottom line is: Don't trust a »one-man« video showing a free energy device. If not presented in front of independent observers it is most likely fake.

Regards

[tinman]

Hot wire removal by software editor? If done thoroughly, you will never detect it.

What about this one: Tesla Working Scheme #1 or that one: Tesla Working Scheme #2

The bottom line is: Don't trust a »one-man« video showing a free energy device. If not presented in front of independent observers it is most likely fake.

Regards

I dont trust anyone that claims to have a free energy device until i(or other 3rd parties) have tested it myself/them self.
Those kookie Russian devices are easily debunked. What im looking for,and hoping other will post,is the !harder! ones to explain--like this one,and the TPU in some cases.

This one is interesting because i do not think an open transformer or RF transmitter could transmit enough EM energy to light that large incandescent bulb-nor do i think that there is room enough in that setup to house a battery that could do the job either.


Brad