Magnets, motion and measurement

[norman6538]

Floor and Butch Lafonte I want to thank each one of you for all the different designs that have great possibility for free power. You two have kept the hope of free
non polluting power alive...

A quick and dirty in vs out measurement on my Lafonte Cascaded device show
1 unit in and 4 units out. Even 1:3 would be very good.

Norman

[Floor]

OkY DOKE Norman


@citfta
png file below

1. two magnets stacked edge to edge.
2. one magnet is above the other.
3. polarities are alternated on the broad face.
4. they will attract to one anther in that arrangement.
5. they slide side ways (in your device) into between the output magnets.
6. the line / junction of these two shielding magnets, should be centered
precisely between the output magnets in the VERTICLE plane.
7. and of course, as parallel to the faces of the output magnet as can be managed.

Note: a single shield magnet tends to be over powered by two out put magnets.
there are other important factors (why the shield magnets alternate face polarities)
which are too much to discuss right now.

       regards
           floor

[Low-Q]

Hi Floor,

Sorry for the slow response.  I have been on vacation for 9 days with my wife and two granddaughters.  Here is the video you asked for.  I have made one change since the last video.  I did add another magnet to each of the repelling magnets.  The action is much stronger now with a little increase in the effort to remove the shield magnet.   Also I see now that I only have to move the shield magnet a very short distance before the other magnets start to repel.  A short quick movement of the shield magnet gets a very quick response from the repelling magnets.  You can see this in the video.

https://youtu.be/tUHtlruVSus

Enjoy the short show,
Carroll

Can you demonstrate how the two opposing magnets react if you push them only half way (Or any place between fully open and fully closed) towards eachother, while the shield magnet is in place?


Vidar

[Floor]

Can you demonstrate how the two opposing magnets react if you push them only half way (Or any place between fully open and fully closed) towards eachother, while the shield magnet is in place?


Vidar

Thats the right direction / point LowQ

As he ORIGINALLY configured it, citfta's build should NOT operate in a smooth / linear manner,
NOR should it produce a net gain in energy.

As LAST configured, CITFTA's build should NOT operate in a smooth / linear manner,
NOR should it produce a net gain in energy.

     floor

[Floor]

This configuration of the design which citfa's build most resembles, was uploaded (by me)
on May 14 / 2019

https://overunity.com/16954/magnets-motion-and-measurement/dlattach/attach/172888/