Magnets, motion and measurement

[Floor]

                  This is a design from 2017, Feb.

@  https://www.dailymotion.com/video/x5d7ip9

It uses only two magnets, is quite powerful and is also one of the earliest of the
designs presented by me (post "Twist Drive" experiments).

Probably over looked by most of the people who check in on /  follow this topic.

What it does is quite simple  (O.U.).   Why it works   is / would  be difficult to to understand,
without a knowledge of the whole trek of this topic under ones belt.

                   best wishes
                              floor

[norman6538]

Yes Floor I remember the twist drive but as I remember about my experiments is resetting for a second cycle takes a good bit of power. I keep saying
1. first we have the set/setup part which is often very easy but requires work in.
2. Then we have the second part which is the power release part. and
3. Last we have the work in to reset so that we can repeat step 1 again.

Am I right Floor about the reset?

After 5 months my doctor finally agreed that my medicine is causing a good bit of my health problems. A little slow on the draw I would say for 6 doctors in the heart group.
Still very busy nursing my wife and keeping up with things. So no time for experimenting yet.

Norman

[ayeaye]

Am I right Floor about the reset?

What are you talking about, there is nothing. No measurements, nothing. Not to talk overunity. Certain people (Floor and Citfta, if they are not the same person) want to get rid of me, because i'm inconvenient. I really measured overunity. In another thread.

Norman6538, be silent, don't say anything. See here is a conflict. Overunity is not important, authority is.

Floor, if you have something real, you show by measurements that there is overunity. You have not done that. If you do, i agree. This is what matters. All the talk and writing, no matter how convincing, doesn't matter, when it doesn't provide any evidence of overunity at all. And all the talk that i don't understand, doesn't matter either, sure i can see when overunity is measured, there is no way how i can deny. But so far, i have done it, and you have not.

I asked you to measure that there is no ordinary shielding in your or Cifta's experiment. You did not, i conclude that you cannot show that, and thus hide it. If you really see that you failed, be positive, admit it, and replicate my experiment. Do something good, and all will be good. If good is what you want.

[Floor]

@Norman6538

The "twist drive"  is a good study / self teaching device.   One can look at it as input by the rotating manet, or as input by the sliding magnet.
Either way it has 3 work  inputs for only one work output.  Except... that there is an attraction along the sliding vector when the two magnets are at right angles.

Do what you need to do.  You guys take care of your self, and don't stress over the topic.

       regards
                  floor

[norman6538]

Thanks Floor. I think you are on to something so I keep trying but its the measurements that count. I have seen overunity with several permanent magnet setups but not over 200% which is required to have enough extra to do the work in in these 3 steps because everybody has to have a self runner.....they will not accept measurements alone.

1. set
2. take out power 
3. reset to repeat step 1.

Norman