Confirmation of OU devices and claims

NickZ · June 26, 2019, 01:24:20 AM

Rick: Sorry for offending you. But, I expected your answer.
You are so full of it... Show the device running a 1000w load. You want us to believe you. Prove your point. I'm not into your game. YOU have shown nothing. No schematic. SHOW the device running the 200w load, leave the device running for days... SHOW it running a 1000w watt load. YOU WON'T. You get a comment and review saying that the battery running your kit drains, you ignore that.
Really!
I've had enough of your insults.
NickZ That's it, over and out...

rickfriedrich · June 26, 2019, 02:20:38 AM

Nick,
Now you are a liar, cause you said you were gone. So is it really "it" this time. I think it is you who needs to put up or shut up. Looks like I am putting up more than you deserve to see. But all you can do is insult with your shouts. You are obviously really angry because you don't want this shown. If it was as you claim then you would just laugh or ignore it. The level of your hostility is revealing to everyone your commitment to suppress this. It is you who are playing the game of I'm gone, but I'm back and I'm gone. Peek a boo!

You have not even watched the video. What's all the fuss? Are you jealous? Or have you failed as a troll?

Yes I am full of this subject. I have put 15 years full time into this. What have you done of any worth here?

You still don't get it. I have shown schematics. This is the motor I have shown for years. This is the SSG circuit. Yes people are fuming now because they said years ago the system was useless. I showed years before this video the same things if you were around. As for the box, if you bothered to read, obviously not, you would see the various options that Tesla gave you. This is not hard to do, it just requires basic understanding of resonance and impedance matching with careful measurements of wire, etc. I have shown everyone the basics of doing this without needing the tuning. But you don't care about such things anyway. Oh wait, where's Nick? He's catching some Zs

and is gone now. Very well we are all better for it.

I guess I have shown nothing. What does it matter? Why so upset unless this touches a nerve. Worried that people will now have what they need to move foreword? Worried that this was what people were calling for?

Guess what? I cannot prove anything over the Internet, just like you cannot prove you're not a troll (although we have all the evidence of such piling up with each attack). If you were around this last week you would have seen I do not try and prove anything over the internet. People come to my meetings and see these things in person. I have shown such things running for 2 days straight over 22 hours people could examine every detail and use their meters and see such things done in several ways. IN THE REAL WORLD, NOT IN CYBERLAND. You are in cyberland and therefore are meaningless. I am both in cyberland and in the real world doing real work. I give real demonstrations but more importantly I show people how to do this. You just attack. You don't even know what you are attacking because you don't pay attention to any details but what you think will suit your agenda here.
You don't get it, we have shown such things running for days. This shows a small example of where people were observing this. I have shown big boats and given rides. Cars, lawnmowers, huge industrial fans and ceiling fans and smaller fans. Generators, etc., etc., etc. This is old news Nick. But then who are you anyway? I have shown 200W loads, 1000W loads, and what kind of load you think a 10,000 pound 26' boat would be. Yes, I ran that first with a forklift motor at 132V 350A. Do the math if you can Nick

Nick, it is not that I won't because I do, again and again. Now my customers come back several times. They really are great people.
I don't get a comment saying that the battery running your kit drains. You invent that Really. I doubt you have had enough. You are hooked, you can't leave this alone. You are all drama, and I have seen your kind for years. You can't make up your mind. It cannot be. I don't want it to be. Or maybe it's all about trying to trigger a reaction. Get Rick to share even more information. Yeah, provoke reaction. You see I am not affected by your games because I am not trying to prove anything to anyone. I only try and help people prove to themselves. I am not trying to control anyone like you are. It is up to you if you want to eat, I can only bring you the blessings of food. You can reject whatever you want. Or maybe you do see it and just don't want others to have it. Who knows the extent of your games. It is just drama without cause. I mean really what are you even doing on a forum like this? Why are you so upset. You need help, serious help.

Quote from: NickZ on June 26, 2019, 01:24:20 AM
Rick: Sorry for offending you. But, I expected your answer.
You are so full of it... Show the device running a 1000w load. You want us to believe you. Prove your point. I'm not into your game. YOU have shown nothing. No schematic. SHOW the device running the 200w load, leave the device running for days... SHOW it running a 1000w watt load. YOU WON'T. You get a comment and review saying that the battery running your kit drains, you ignore that.
Really!
I've had enough of your insults.
NickZ That's it, over and out...

popolibero · June 26, 2019, 02:49:02 AM

Rick,

I'm not just thinking about this, but before I throw a circuit together there are some things I need to visualise in my mind.

you said: "BTW, some of the nodes in the box are what I have shown already. But the ones with the big 100W LEDs are other arrangements." Maybe theses arrangements are the transverse ones, air-grounded by "what surrounds the box"...

Say I run a solid state SG as my one wire impulse generator, do you see a problem if it is run from a grounded power supply to make these experiments, or even run by a battery but the fet driving circuit is run from a little 15V power supply? Does this create problems to be connected to the ground on the input? Else I just run everything from the battery.

Also, from the video you posted, I see it doesn't matter if the energizer coils are small, but you said that the first coil on the one wire transmission determines the output of the following ones, so, at least the first one better have some mass, correct? It's probably best to make them all equal to get them resonant at the same frequency...

So the impedances give the best results when in resonance, and you also said impedance matched. Do you mean matching the impedance of the tanks to get resonance, or matched impedance from the resonating impedance to the load, like a step down secondary?

thanks,
Mario

rickfriedrich · June 26, 2019, 03:04:48 AM

You really have to go back and look at Tesla's circuits and read what he said about how this works. Until you get the idea you will be looking for certain parts arrangements to hopefully stumble upon something. That just will never work. "throwing a circuit together" just doesn't work. It first clicks in the mind and then you can make it work many ways.
There are more than several options there. The transverse gives you the option to expand the network.
Grounded input supply is different. That is not what we are doing here. It is not impossible to do but is not this. The idea is that you don't need a supply once it is set up. Grounding is a very significant influence, especially where grounded...
What I said about the first coil is only the basic level testing not tuned/resonance.
Equal or balance is important and remains to be understood.
There is matching impedance with the load and matching with the input--two different things.

Quote from: popolibero on June 26, 2019, 02:49:02 AM
Rick
I'm not just thinking about this, but before I throw a circuit together there are some things I need to visualise in my mind.
you said: "BTW, some of the nodes in the box are what I have shown already. But the ones with the big 100W LEDs are other arrangements." Maybe theses arrangements are the transverse ones, air-grounded by "what surrounds the box"...
Say I run a solid state SG as my one wire impulse generator, do you see a problem if it is run from a grounded power supply to make these experiments, or even run by a battery but the fet driving circuit is run from a little 15V power supply? Does this create problems to be connected to the ground on the input? Else I just run everything from the battery.
Also, from the video you posted, I see it doesn't matter if the energizer coils are small, but you said that the first coil on the one wire transmission determines the output of the following ones, so, at least the first one better have some mass, correct? It's probably best to make them all equal to get them resonant at the same frequency...
So the impedances give the best results when in resonance, and you also said impedance matched. Do you mean matching the impedance of the tanks to get resonance, or matched impedance from the resonating impedance to the load, like a step down secondary?
thanks,
Mario

popolibero · June 26, 2019, 04:01:40 AM

You know Rick, you really have a gift in trying to make people look like idiots. Do you do this to always have a feeling of superiority or what?

I didn't mean I'll just throw whatever circuit together, ok? I'm trying to articulate precise questions like:

Can having a ground (input power supply) hinder the basic one wire experiment I'm trying to do? Should I better avoid it??? Yes, no??

You wrote: "there is matching impedance with the load and matching with the input--two different things". Yes I know that. My question is which one were you referring to when you mentioned it earlier?

But I'll probably always just be a fool to you no matter what I do or write, so I may just stop begging for your guidance and go back working on my own.

Mario

Quote from: rickfriedrich on June 26, 2019, 03:04:48 AM
You really have to go back and look at Tesla's circuits and read what he said about how this works. Until you get the idea you will be looking for certain parts arrangements to hopefully stumble upon something. That just will never work. "throwing a circuit together" just doesn't work. It first clicks in the mind and then you can make it work many ways.
There are more than several options there. The transverse gives you the option to expand the network.
Grounded input supply is different. That is not what we are doing here. It is not impossible to do but is not this. The idea is that you don't need a supply once it is set up. Grounding is a very significant influence, especially where grounded...
What I said about the first coil is only the basic level testing not tuned/resonance.
Equal or balance is important and remains to be understood.
There is matching impedance with the load and matching with the input--two different things.