High voltage HHO by IronHead

[IronHead]

Dingus Mungus The NS-T cell is obsolete and no longer . The NS-T also requires alot more equipment to run. There is no gradient of operation it ether does or does not work.
I will do what I can to write up something for you on that cell and PM it to you.
Along with a couple other guys that insist on working with the NS-T. First ,one small piece of Nitronic  50 Stainless steel is going to cost you more than all the SS in the Series Cell. About 300USD for 1"x72"  not sure if you can purchase smaller amounts. You will have to look around

http://www.onlinemetals.com/merchant.cfm?pid=10707&step=4&showunits=inches

It is much more expensive to build with thousands of dollars worth of equipment to support the system . The electronic control  delivery system  must be hand built as well . All this for the same production that you will soon see here in the  cheaply built S-Cell .
Also I hope you have access to a micro cutting laser if not I know where you can send the parts to have them perfed. This is also going to cost  a good chunk . It is the holes that build massive electrical or electromagnetic fields that make this system work. These holes may also be acting as some kind of micro wave guides , I am not sure.

There are nearly half a million holes in a "radial fashion" in the small piece of Nitronic
along with the Tungsten

Now that the cat is outa the bag  , what do you want to do?

Looks are deceiving
IronHead

[IronHead]

I  must add that if I were to teach the NS-T . There will be a few out of a thousand  people that could build it and 1 out of those few that can make it work. So I have made the decision to teach the S-Cell that anyone can build and get immediate results .
In 60 pages many have had great results unlike many of the other types of research going on in this forum. So I think we are doing well here.

So in the next few pages I am hoping to see people "jack hammering" there cells and reporting there results.


This is the video that inspired me to work with series . Thats Joe on there inventor of the JoeCell. This video is much older than the posters upload
http://www.youtube.com/watch?v=BSdxEonivNU




I hear you brave young jables you are hunger for the Rock. but to learn the ancient methods secrete doors you must unlock.
IronHead

[IronHead]

I just bought one of these  PWM units to test and see if it is a good solution  for some of you , and it's low cost .
http://cgi.ebay.com/PC-Interface-PWM-Control-Hydrogen-motors-KIT_W0QQitemZ270130064049QQihZ017QQcategoryZ78190QQcmdZViewItem

[s_c_engineering]

Hey IronHead, thanks for doing all of this i really appreciated it.  i have been following this thread from the sidelines since page 14.  And i built a cell with config +nnnnn-nnnnn+ on each side as i was experimenting with lower voltage, im still going to build the one you recommend, just havent got around to it yet, i think im going to make it enclosed though and try to pump water thru it as you were saying.  I have a question and it may be off topic but have you built the VIC circuit and gotten it to work?  i have just received the components for my pulsing circuit and i just have to cut out my pcb so i can assemble it.  I was also thinking, i noticed that the VIC circuit is a whole lot like the coils and chokes used in charging the capacitor in a tesla, have you experimented with using the vic without the diode and using ac to drive it?  thanks
i will be following this thread and will also be posting from now on.  sorry to hear about your hands and i really appreciate what your doing here.

[kokomoj0]

Whats a VIC circuit?