Selfrunning cold electricity circuit from Dr.Stiffler

[DrStiffler]

@amigo

Forgot to add, the reason the LED brightness falls is the LEDS have changed the resonate point of the coils, you have to retune to the max point again. If in tuning your oscillator the freq. changes rapidly you may not be able to find the exact point. I know this is a fine line, an oscillator that will swing over a wide bandwidth and yet be adjustable in a small bandwidth. So goes experiment. 

[hartiberlin]

Dear Ron,
so what exactly is exciting the coil-cores,
if you use just a ground wire ?
Can you try to find this out please ?

[DrStiffler]

New video;

http://www.youtube.com/watch?v=jn8u8EIJ8Gk

[Localjoe]

Rstiffler said both these quotes on this thread ... Stefan wasn't off base at all for asking that question about the ground noise and single wire conductor

Getting somewhat concerned about what you do not understand, or do not want to. Where in this diagram do you see a parasitic plate or a signal generator.
Please stop trying to change or put works in my mouth because I will not just jump to the end.



4) The Al plate does not worth the same as mass does in Stefans example. When using a proto-board with the backing Al plate it need not concern you until you wish to use it as a parasitic amplifier, in which case you would drive the circuit by applying your signal to the outer most plate.

[DrStiffler]

Rstiffler said both these quotes on this thread ... Stefan wasn't off base at all for asking that question about the ground noise and single wire conductor

Getting somewhat concerned about what you do not understand, or do not want to. Where in this diagram do you see a parasitic plate or a signal generator.
Please stop trying to change or put works in my mouth because I will not just jump to the end.



4) The Al plate does not worth the same as mass does in Stefans example. When using a proto-board with the backing Al plate it need not concern you until you wish to use it as a parasitic amplifier, in which case you would drive the circuit by applying your signal to the outer most plate.

If you want to say something, say it, why extend the thread by some form of insinuation?

If you want to pursue the work great otherwise one could infer you to be another distractor  ?