New Korean magnet motor

[Paul-R]

I haven't seen the video but it sounds like Ben Teal's motor:
http://www.free-energy-info.co.uk/Chapeter1.pdf
See page 37/48.
Paul.

[pese]

I haven't seen the video but it sounds like Ben Teal's motor:
http://www.free-energy-info.co.uk/Chapeter1.pdf
See page 37/48.
Paul.

This here work:
http://www.free-energy-info.co.uk/Chapter1.pdf

Gustav Pese

www.pesetrier.150m.com  (most in germaln - private url)

[Yucca]

My observations:

The only thing the website mentions is "magnetic attraction" motor.

The central drum is driven, the pistons take energy off somehow, apparent because as Low-Q mentions the left set of pistons lose synch when the speed is increased too much.

When you study the stationary engine on the video you can see that the drum has some very strange non geometric shapes or indentations on it, I was wondering what this could be considering the rest of the build is very ordered and geometric. Also when you hear it run it seems to knock, I wonder if this is just the noise of the pistons on their linear guides, or could it be that the knock is a designed brief collision between the pistons and the raised section of the drum? I would expect them to have used fine linear bearings with no slop in them and I´m sure their big and small ends are spot on, it doesn´t look like they have built on a budget. That could explain the strange shapes or indentations on the raised section of drum after along time running.

Yucca.

[Pirate88179]

I hate to sound like a skeptic but, with all of that beautifully machined components working, why did they not show where the belt on the pulley on the right was going to?  They showed the device from almost all angles except that one.  there was a pulley on the right hand side that had a belt that was clearly going down to what?  I hate videos like this.

Bill

[Yucca]

Hi Pirate88179,

I´m pretty sure that the belt from the central drum is connected to a drive motor in the lower box.

The whole unit is probably a testbed for their research with which they will be able to monitor input power and output power as they adjust things.

Of course whether or not they have achieved COP>1 is the big question, I have my doubts.

Yucca.