Keppe Motor simular to Newman-Bedini combination

[gmeast]

Okay!  here you go

http://www.youtube.com/watch?v=3Rbxqmk3GH0

Luc

Great Luc,

Thanks for posting the video.  As you can tell from my pics of my Keppe housing ... looking at the bearings ... my magnets will rotate end-over-end long ways, N-S, but your construction is very similar. 

Thanks again LUc,

Greg

[gmeast]

Why not attach a belt from the rotor of the keppe motor to a rotor of a generator to get some usable energy?  You could glue the bar magnets together as usual but then also glue some plastic fittings so the rotor is circular and a belt will fit.  The keppe motor could supposedly run itself and the generator at the same time right?

HI,

My understanding is that the Keppe motor is best at delivering torque and as such would be best at driving mechanical loads like fans, pumps and of course generators.  Yet in one of the videos they are shown harvesting electrical power from the motor's circuitry and charging a battery.  But still I think it is best at driving a mechanical load.  I purchased the manual and am also building a motor as seen in pictures from my earlier posts.  I will  mount the motor housing on a second set of motor shaft bearings and attach a moment arm to measure motor torque (reaction torque) via a scale (same as in one of the Keppe videos). 

It is my understanding that a 'complimentary' torque is generated by the 'complimentary' scalar energy harvested at resonance of the pulsed DC power to the the motor ( I like the word "harvested").  But this is a common principle used for other self-charging technologies like Bedini's and Newman's.  The difference(s) seem to me is, again, to be that the motor is built specifically for torque from scalar energies and not for charging batteries or making power from mass.

Peace,

Greg

[LatexDucky]

how about build the rotor of a generator around the rod that goes through the rotor of the keppe motor so that they are the same thing basically

[gmeast]

how about build the rotor of a generator around the rod that goes through the rotor of the keppe motor so that they are the same thing basically

Oh, I forgot to say that the load will be a fan on the motor shaft ... just like in one of the videos.  Eventually a generator might be in order, but for measurement sake it would be difficult to determine the output of such a small motor using a generator because of the losses and all of such a small generator.  A fan is actually a good way to load up a small motor like a Keppe demonstration motor.  They say it produces more equivalent output power than it consumes so I could use a small PM motor as a generator as a load through a resistor.  Still I'll need the reaction arm and gram scale for a truer power determination.

Greg

[gmeast]

HI all,

As of the moment of this writing, you can download the Keppe Motor Manual for FREE at the Keppe Motor Club

http://keppemotorclub.bestforumpro.com/forum.htm

Select the 'General Forum'.  I don't think you even need to log in  Look for the posting by Abrakadabra.

I had to pay $50.00 for the thing!  So get it while it's hot.

Greg