Low Current HHO Production.

[pese]

Eve , if one of the calculation is incorrect.
If he produce with 4 amps @ 12 volt more Hydrogen , as all other constrction ... than is this an way to give attention and gratulations..
GP

[ramset]

YES   Pese if Hydrocell is producing more HHO with less energy  he needs to be congratulated
     Chet

[sucahyo]

the dipole is tuned to a frequency of exactly 42.854khz
when power is put into a dipole and pulsed at its tuned frequency resonance is acchieved.

What equipement that you use to tune the dipole? How do you know it resonate at that frequency?

[Hydro-Cell]

a dipole can be tuned to resonance using a grid dip ocsillator.
this small device will put a signal into the dipole, in this case 42.854khz. the grid dip oscillator has a tuning capacitor on it that allows you to tune to the dipole. this will indicate if you have either to many or not enough windings on the dipole.

if the oscillator is set to 42.854khz exactly and the dipole is resonant the meter on the grid dip oscillator reads zero. this shows that there is no feedback or harmonics being returned. using this method you get maximum energy transfer.

a dipole of this size is dangerous especially at these frequencies. just 10wats into this dipole could cause stinging in the eyes and also rf burns.
1000watts could do major damage to a person. it must therefore be protected inside a faraday cage while switched on.

[Paul-R]

The dipole is tuned to a frequency of exactly 42.854khz
when power is put into a dipole and pulsed at its tuned frequency resonance is achieved.

I think you will find this of value:
http://www.free-energy-info.co.uk/Chapter10.pdf
Don't forget that it is the basis of the Meyer and Boyce
systems that the voltage (rather than the current) that
does the business.
Paul.