Feedback To Source

[gadgetmall]

@hartiberlin
Hi . This was My 9th Bedinipowersupply .I gave them Away for Christmas ! you are talking about the first one . The one with the 48 volt fan is running off a 12volt battery and Just Built last night .  . .
yes . i will get a number for you but this is Jesus's thread and i just posted My latest Video for encouragement for Him and His Project. We can Discuss It on My Thread Started By Goat` : Fusionchip's Bedini Feedback to Source!!! There is a picture of My fan Back there !

@Pirate . I will Try that . So many Things I was Asked to do with it .  Thank you Guys and Thank you Jesus for the Space here .

[Mk1]

@jesus

Your alternator project , if you recoil it with soft iron coil , you will reduce the magnetic pull and reduce friction , This is a old story that most won't even try.

[nievesoliveras]

@All
Here is My New Video of a Powersupply bedini FEEDING BACK TO SOURCE .. Any Comments ??
http://www.youtube.com/watch?v=BbSV-BqGnYw

Congratulations @gadgetmall!!!
I have not had good luck lately.

Hi Jesus,

Very sorry that my suggestion did not work as expected,  I based it on your measured circuit you included in your Reply #143 a bit earlier. 
I think the basic problem is the diode bridge connection directly to the Bedini output, a kind of isolation would be needed,  probably a third coil wound directly onto the pulse motor's presently 2 coils could directly drive the diode bridge, giving an ground-independent output  (i.e. the bridge cannot "see" any other voltage or current galvanically from the rest of all the circuits). 

rgds, Gyula

Dont worry, I am just learning here. If it can be done I will do it.

@jesus

Your alternator project , if you recoil it with soft iron coil , you will reduce the magnetic pull and reduce friction , This is a old story that most won't even try.

I am trying to obtain a circuit that converts the alternator on a motor, but I forgot where I saw that information.

Jesus

[nievesoliveras]

@mvmcman

Thank you!
You should make your posts on the thread not on my email.

I received @gadgetmall feedback to the source circuit. I made some small editing and post it here as an example of a working circuit and as reference.

@gadgetmall

You are always welcome on this thread.

Jesus

[nievesoliveras]

@all

I tried this version of @gadgetmall circuit and the results were not different than the results from the circuit with the rectifier.

I used a flash circuit cap 300v 80uf and I configured the circuit as the graphic.
When I try to run the motor with all connected, it does not run.
If I disconnect the wire coming from the output coil to the 300v cap, the motor runs.

This is a crazy situation I have here.

Jesus