Stanley Meyer Explained

[Toolofcortex]

Here let me give you an example of bringing a manufacturing process in house.

Instead of paying somebody to assemble my boards, I decided to buy this retrofit kit, to turn a regular oven into a high precision reflow oven.

Total price: 250$ USD.

--------------------------------------------------------------------

Its this divide and conquer strategy that will make or break you as a business man.

Lets simulate if I was making this Stephen cell.

Now, I have my pcb software:free

Digikey Parts: ~100$

China PCB shops: 200-300$ I might make a few impedance boards.

I need: A plastic circular tube, and a plastic disk, plastic seperator/holder for the tube: 500$. Glue this. It will all be surrounded by water as suggested so leaks are of no concern.

For the SS tubes: Off the shelf pair, machined third if problems, will look for all off the shelf standards.

I think I would come under 2700$. Ok yeah I'm good at this but still, it was free money, you cant expect alot out of gofundme.

[Toolofcortex]

https://www.ebay.com/itm/24V-Positive-Negative-Voltage-Regulator-Module-Board-Based-on-7824-7924-x1-/132716246379

Since this is a MOSFET amp, this is all you need.

The cell should be driven by powerful batteries 12-13.8 volts

I think some F4 microcontroller with 3x ADC can do this, but there might till be need for lowpass, I am not sure.

This circuit is for zero programming/turn the knob.

But close to the cutoff, since this is a multiphase type scenario, the imperfections of the filter components play a role in phase shift/amplitude drop.

I would be surprised if you needed more than 10khz, considering that the sine component measure ~500hz in the patent application.

Now if any anomalous effects were detected, perhaps we could figure out other more efficient design topologies.

[kolbacict]

Yes, not enough time, but unfortunately I have to deal with routine affairs. But I hate these things.
But I will do it anyway. Here is what is already there. Bottom to measure gas volume.

[kolbacict]

Another tormented thought. Why do I see all cells are two-dimensional? Be it a cylinder in a cylinder or flat plates.If we have a water molecule is a three-dimensional tetrahedron, then can arrange three electrodes in the form of a three-dimensional grid?
And make full use of your three phases.

[Toolofcortex]

Dont do it.

You will only do it poorly and feel discoueraged.

The cells are as they are because greater men said so and we will copy them.