The Master Of Magnetics "Steven Mark"

[hartiberlin]

I have found that the spikes at my output coil are just capacitive transfer from the control coil.
The control coils can even be left one side disconnected that the spikes remain the same.
Pulsing the control coils at 1.3MHz excites a resonance around 3x that frequency on the output coil. The power available is nothing. A 1Mohm resistor totally damped that oscillation.

So, nothing new here. We must look for something completely different...

Hmm, did you modify your control coils at all ?
only 2 windings is a bit too low I guess, so you could
not see much...I guess you would need at least 100 windings to see
something at all and over a larger surface area of the output coil.

Interestingly is your statement that all the energy
transfer is purely capacitively and that a shortout of the output coil
does not need more input power of the driver circuit.

So the next question is, how much power can you get out of the
output coil when you have optimized it and that does not reflect back onto the
needed input power...
So can Lentz law being broken with it ?

[hartiberlin]

Kosh,

I re-did my experiement with pulsing my torrid via the control coil and observed the same results as you, a ringing waveform in the large coil. Just validating your experiement since I had also experienced this before.

starcruiser,
what do you exactly show here ?
The output coil ?
At which timebase setting and is this just after the control
coil has shut off or when ?
How long was the control coil pulse ?

Thanks.

[mrd10]

Dear all,

I have created a page on my site which will contain any good SM details.  So far it just contains the videos which you can download and keep.

More to come soon...

SM Page: http://www.ctglabs.com/stevenmark/smindex.htm

Main Page http://www.ctglabs.com


Regards,

Dave.

Hi Dave,

Very nice site, I like it, hey add this video to your collection:- http://video.google.com.au/videoplay?docid=-6540638039071490742&q=Electromagnetic+generator
It sounds like that guy from the elemental rods video,
I think its the same guy, by his voice.

Cheers,

Dom   

[hartiberlin]

New coil, same results...  Have to try again with bailing wire...

Hi Kosh,
now I see, that you get about 6 Volts peek2peek output on your
output coil and the spikes now have real area under them,
so no real spikes with low energy, but real waves with
energy in them.

Is this the unloaded output coil shown ?
What about a load on the output coil ?
Can you show the difference in output scope shots with
load and w/o a load ?

Are you pulsing at the resonance frequency of the blue
output coil yet ?
What is its resonance frequency ?
Maybe put a capacitor in parallel with the output coil and
thus lower the frequency and try again.

Many thanks for your tests...

Regards, Stefan.

[mrd10]

Ok DAve,

Yeh theres alot of crap on the net, and its easy to make shit up. Its a real shame for people to do that, I can see no point in it, other than frustrate the people who want a better world.

Have you been reading my posts?
I believe your correct that this power source for SM device has to come from somewhere other than that we know of.

From the facts ive gathered these are the things which stand out

-2 rings
-a set of coils ...lol  obviously
-magnetic field and resonance    .......relate to two prong tuning fork and the fact SM devices vibrate

I've made calculation from the two tuning forks that i had, that the inner diameter should be about 125mm, for 7.8hz.

Anyway lets keep at it. Im Eager

cheers,

Dom