Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[Zeitmaschine]

Hi Zeitmaschine,

where does the cable 4 go and where does the cable 3 come from?
can you explain the connections in simple steps?

Regards

I think cable 4 powers the primary coil(s) of the second transformer (the dark one) and cable 3 comes back from the secondary of that transformer with high voltage. But not too high high voltage, because of the rather thin isolation. Also I think a 3-phase device needs only single-phase high voltage.

Main question is: What to do with the high voltage? Connect the 50Hz resonant high voltage to what? A spark gap would simply short-circuit the high voltage, I can't see any use in doing that.

Also output transformer is not transformer but choke where High voltage are producing light ionisation

cosmoLV says something about light ionization. But ionization of what? The LC choke circuit perhaps?

Could it be that all three open secondaries b, c, d, of the choke transformer are connected to the high voltage of the second transformer via the common connector a?

[stivep]

EVERYTHING BELOW  IS DONE FOR FREE ENERGY experiments:




SPECTROSCOPY/ NUCLEAR/ PART#2 :X-ray https://www.youtube.com/watch?v=CQ3gPFfgDp8


All one need to know to understand science of radiation in respect to Colman FE, Andrea Rossi LENR, and mechanisms of nature. DIY is always easier for me when help comes from scientific community in easy to swallow form.That is what I provide to my Colleagues in science and that is what they provides for me:


parts of video  in time frame:


- time 00:00   easy introduction to identification of periodic table elements in anything you have around.Explanation of device.
                    How much gold is in your ring,(how much  gold is in GOLD? )

- time 03:37   Basic theory and how the measurement is  created.( easy, but not for idiots, -directed to strongly motivated                              viewers)


- time 09:30   How big  specimen  can I measure? ( solids, liquids, powders)


- time 10:51   Calibration( that is to be applied to  any spectroscopy- alpha, beta , gamma, x-ray)  by comparing to calibrating                        fixture -( just a piece of material that has known elements of known values)


- time 17:50    Can we place the sample now? (.......granules of Gold in plastic bag)


- time from 20:57 to 23:48    It does not always pay to educate someone you trying to convince to give it to you. I almost lost                                                it...........gushhhhhh but............... he is a good man..........


- time  24:13   My first measurements and crushes.... nice chunk of gold under scrutiny, 


-34:30 some reflections ......


Wesley 

[stupify12]

Man. I will now posted on your question about this transformer. Here is my answer, this is the patent which i replicated from Tesla that defies every physics and which was everyone looking for this so called Free energy device. It is so simple yet taken for granted.  It is the prototype of Tesla Magnifying Transmitter which Tesla works until he perfected it to Wireless Propagation of Energy, everyone should understand it first before you talked all about non sense Resonance whatsoever. This is the secret of Tariel Kapanadze which he always talk about so simple that everyone will laugh.   

This is for you guys, Im just giving you a small push at your back so goodluck and happy experimenting. You can powered it with Induction Heater Circuit to test the circuit if it really works. And compare it to the first Akula Free Energy Device which Akula talks about Tesla this is the patent.

http://www.teslauniverse.com/nikola-tesla-patents-593,138-electrical-transformer

Meow

And the other building blocks are chokes and transformers.

All right. There remains one simple question to be asked: Why is it that a carpenter (Stepanov) and also others (like Kapanadze and Barbosa) could stumble over a Free Energy transformer configuration by chance, but people doing experiments since years on their workbenches do not? Is it because they are all working with three-phase transformers? Actually YES and NO. It is NOT because of the three-phase feature. It is because of the STEP-UP feature of those transformers. Normally you won't get a 220V/50Hz step-up transformer with a number of KV output at the next radio shop. But you will get a 380V step-up transformer in professional three-phase design.

Meaning? Don't experiment with flybacks. Neither high frequency nor DC nor pulsed high voltage (with or without a spark gap) will do it. Use 50Hz sine wave high voltage (e.g. from a microwave oven transformer) instead. The high(er) voltage has to be in resonance with a LC circuit.

So as it appears, we are now down to three single building blocks: Two transformers (one step-up, one as choke) and one capacitor. Happy connecting!!

Also quite interesting how quickly this posting of mine got buried without any real reply.

Regards

[jbignes5]

 Ok way off subject here but lets get a few things straight.


Tesla's wireless system did not use Hertzian waves, Period.


Yes the system was never meant to be 100% broadcastable. He stated that at Colorado he could only attain 98% efficiency at the "Antenna". The efficiency was only an indicator of breakdown at the antenna which resulted in loss as Tesla put it. At the NY site he was addressing the issue with a new type of vacuum single terminal tube. This tube allowed the longitudinal streams to lower in intensity enough to spread out and not cause the air to break down at the surface of the tubes. The tubes were shaped like bulbs.


If the system Tesla was working on only affected one receiver then how in blazes was he gonna give the whole world power from one station? Think people..... The greatest thing about his longitudinal waves were that they were one way. They did not oscillate back to the source. If they did it would have ruined the source and degraded the source power. Tesla's ideas about using this for a signalling system were not yet implemented yet. Meaning that you had to have another unit slightly off tune at another resonant frequency to communicate to another receiver. Then you could transmit two way communications. His original ideas were sort of a teletype system at first then a second channel would be added for two way communications.


When Hertzian waves are employed you get a feedback to the source. Case in point: any exciter setup we see today. This is a field of back and forth waves. when you put a load in the field it affects the source and further loads in the field will draw a portion of the total field down. This is very evident in all experiments with these types of fields that we see today simply because the field is oscillating back and forth in respect to the source of the field. This is RF and not Pure longitudinal fields. A longitudinal field would flow much like a stream of water. Any disturbance of the stream down stream does not affect the source in any way. Only local effects can be seen where the disturbance is in that stream.


Most people see the Tesla wireless system as being a transmission from the antenna but it is not so. The broadcast source is the planet itself and radiates outwards from the earth. This negates local disturbances totally. The topload or capacitance was only used as a Virtual ground to pump the Earth. You could think of this like this. The capacitance is to be pushed against forcing the earth to be energized and radiate outwards. Lets try a little experiment here. Try to push a car by yourself. Hmm very hard right? Now put a wall behind yourself and use it to push against. Not so hard now right? Same concept.


To sum up Longitudinal waves are stream like. They move like this (Source)--->----->------>   The intensity is what changes not the direction of travel. Each successive wave overlaps the other and this is where the standing waves form. Each stream has a value. When one value is compared to the next you have a difference. This difference is the one stream when compared to the previous stream in Time.


Hope this helps.
jbignes5

[stupify12]

Everything you cited is correct and I understand perfectly that Tesla Transceiver are not the same with Hertzian waves, the energy travels/propagate within the Ground/Earth.

Thanks for your great info and detailed, happy to have some people that really understand how a Tesla Transceiver works.

On my post above, once you disconnect one of the GROUND/EARTH terminal the load= bulb wont light even a little, if everything meets the novel design of the great Nikola Tesla, any load, any secondary coils as much as u like will only boost the performance of such device. That transformer above wanted a overloaded scenario, it really wants to have a SHORTED circuit=close loop coil on the secondary to x2 its power output on the Load. The Tesla 1 wire transmission is the prototype to the Tesla Rarefied Gas Transmission then to the Wireless Transmission of Energy it is just improvements of simple device which works solely on energy propagation on the Ground.

Meow..

Ok way off subject here but lets get a few things straight.


Tesla's wireless system did not use Hertzian waves, Period.


Yes the system was never meant to be 100% broadcastable. He stated that at Colorado he could only attain 98% efficiency at the "Antenna". The efficiency was only an indicator of breakdown at the antenna which resulted in loss as Tesla put it. At the NY site he was addressing the issue with a new type of vacuum single terminal tube. This tube allowed the longitudinal streams to lower in intensity enough to spread out and not cause the air to break down at the surface of the tubes. The tubes were shaped like bulbs.


If the system Tesla was working on only affected one receiver then how in blazes was he gonna give the whole world power from one station? Think people..... The greatest thing about his longitudinal waves were that they were one way. They did not oscillate back to the source. If they did it would have ruined the source and degraded the source power. Tesla's ideas about using this for a signalling system were not yet implemented yet. Meaning that you had to have another unit slightly off tune at another resonant frequency to communicate to another receiver. Then you could transmit two way communications. His original ideas were sort of a teletype system at first then a second channel would be added for two way communications.


When Hertzian waves are employed you get a feedback to the source. Case in point: any exciter setup we see today. This is a field of back and forth waves. when you put a load in the field it affects the source and further loads in the field will draw a portion of the total field down. This is very evident in all experiments with these types of fields that we see today simply because the field is oscillating back and forth in respect to the source of the field. This is RF and not Pure longitudinal fields. A longitudinal field would flow much like a stream of water. Any disturbance of the stream down stream does not affect the source in any way. Only local effects can be seen where the disturbance is in that stream.


Most people see the Tesla wireless system as being a transmission from the antenna but it is not so. The broadcast source is the planet itself and radiates outwards from the earth. This negates local disturbances totally. The topload or capacitance was only used as a Virtual ground to pump the Earth. You could think of this like this. The capacitance is to be pushed against forcing the earth to be energized and radiate outwards. Lets try a little experiment here. Try to push a car by yourself. Hmm very hard right? Now put a wall behind yourself and use it to push against. Not so hard now right? Same concept.


To sum up Longitudinal waves are stream like. They move like this (Source)--->----->------>   The intensity is what changes not the direction of travel. Each successive wave overlaps the other and this is where the standing waves form. Each stream has a value. When one value is compared to the next you have a difference. This difference is the one stream when compared to the previous stream in Time.


Hope this helps.
jbignes5