Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[a.king21]

Tariel Kapanadze Aquarium2 Video de-bug
http://www.youtube.com/watch?v=VPknKQFrmqY
This  is the best I could do to make quality better.




Please note that in the  video I have  compared 
outside of house picture of concrete  floor made by  mr  King team few moths ago and
my picture of the same but with no cement in it in 2011 in September.


To make ground  and if you want to make  quick and good you drive copper  rods into it
about 4f  than you put clamp on it.
The  cement was done  fresh with one screw to it?
please ask yourself questions I  have  mentioned in video and look at  pictures comparison




Wesley

My understanding is that the Tesla transmission of energy through the ground required a large metal structure, (acting as a receiver) in the ground.
The ground wire was disconnected for a few seconds with no effect on the load.
Even if Tariel is transmitting electricity we would still be interested in doing a deal with him, because it opens up  the prospect of electric cars without the need for huge power batteries. Then maybe we would drop criminal prosecution against him and his team. Of course we would have to repay all the scammed victims.

[frantz]

Hi all,
I would like to ask all of you.
Do you know why TK in his presentation of small device connecting always resistive load?
Not inductive load like one phase motor for 220V! f.ex. drill, grinder, hair dryer, vacuum cleaner. etc.
Maybe on output we don't have AC sinus but ramp or triangle signal?

Power measured by multimeter will be the same, frequency too... but AC motor will not work properly...


Next one:
In presentation in Germany he has connected AC generator connected mechanically to electric motor (i think DC motor)....
on there I saw only inductive load like hair dryer....

[verpies]

The ground wire was disconnected for a few seconds with no effect on the load.

Was this shown on the video?

[Free.Energy]

The ground wire was disconnected for a few seconds with no effect on the load.

If the ground is disconnected the energy is built up and take many seconds to go down. 

[Free.Energy]

Hi all,
I would like to ask all of you.
Do you know why TK in his presentation of small device connecting always resistive load?
Not inductive load like one phase motor for 220V! f.ex. drill, grinder, hair dryer, vacuum cleaner. etc.
Maybe on output we don't have AC sinus but ramp or triangle signal?

Power measured by multimeter will be the same, frequency too... but AC motor will not work properly...


Next one:
In presentation in Germany he has connected AC generator connected mechanically to electric motor (i think DC motor)....
on there I saw only inductive load like hair dryer....

The same in the green box video and orange blanket video.  All only resistive loads.  If device is like charging capacitor then output is DC or pulsed DC.  I don't think is pulsed because it goes down slow.  May be dirty DC.

In both videos there is the can device between the power to load and the inverter.  I think this is change the messy high voltage DC to 12v DC.

No one sees we are close now?