Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[Zeitmaschine]

some extraordinary knowledge like Don Smith

I have never seen any demo of a working Don Smith device in self-sustaining mode.

Hence it surely can't be that this Don Smith is an agent with the CIA instructed to make people think a free energy device is on its way to the market already, so it is not worth the effort to construct one themselves?

[poynt99]

Sometimes for A reading attach small car lamp 12V, 1A and measure in series,
just to have any load and at 1200V setup I measured 550-600mA, but often I just
do it without load and than is 900-1100mA (1.1A).

My last setup can gain 980 mA /1200V from 250mA / 12 V input from PC power supply with
help of backfeed.

Does anyone here see a potential problem with this claim 

If so, shouldn't this be the focus before anything else? 

[Hoppy]

Does anyone here see a potential problem with this claim 

If so, shouldn't this be the focus before anything else? 

There are clearly some people posting in this thread that do not have even a basic grasp of electrical principles and yet are trying to unravel the mystery of the TK device by experimenting using circuitry and test equipment that work on these very same principles!

[wattsup]

I really object to your brazen unprovable lying accusation about the cameramen. The TK vid was taken on an iphone and the copy downgraded (the original was 350 meg) and emailed to me. We have absolutely no connection with any one else's video. Stop talking complete bollocks. It makes me doubt every post you have ever made.

@a.king21

That was just a joke for guys in the know. SM had a habit of making these killer bad quality videos just like the last TK video. I never lie, but I can joke around. Sorry if you took it the wrong way.

@ALL

So this TK coil is not wound with 14 awg mutil-strand copper wire.
See image below shows a close-up of that connection to the transformer and compare it too an image I took of my 14 awg. I would say the blue wire is a HV type wire of 18 awg at best but able to handle high voltage at a good amperage.

The next image is a remake of the full diagram posted by @Bernhard, that I modified. Some said the TK coil was not used but this diagram will show that it is used as shown in series to the load.

Yes at the two layer end the two wires that go to the load seem to have a wire traveling through the TK coil but they do not. They just shoved a small length of the load wire inside the tube opening to try and confuse the viewer and to not flagrantly show the wire from the transformer is going directly to one side of the load.

The impact for builders of TK coil using standard multi-stranded copper wire compared to using a one strand HV wire is not known. Of course with HV using a multi-strand will cause many inter wire arcing potential that seems to not be desired by TK, so I will find the right wire to make the TK coil.

wattsup

[poynt99]

Sometimes for A reading attach small car lamp 12V, 1A and measure in series,
just to have any load and at 1200V setup I measured 550-600mA, but often I just
do it without load and than is 900-1100mA (1.1A).

My last setup can gain 980 mA /1200V from 250mA / 12 V input from PC power supply with
help of backfeed.

Provided the measurements are performed a certain way, anyone can produce similar test results using a Joule Thief or blocking oscillator circuit.