All of Stanley Meyer's Equipment FOUND Including Dune Buggy! (Videos Here)

[hartiberlin]

@MarkE,
then how do you think he drove his Dune Buggy car  ?

Do you think he had so many batteries that produced enough HHO gas to drive it this far ??

https://www.youtube.com/watch?v=a74uarqap2E

[MarkE]

@MarkE,
then how do you think he drove his Dune Buggy car  ?

Do you think he had so many batteries that produced enough HHO gas to drive it this far ??

https://www.youtube.com/watch?v=a74uarqap2E

Stefan, that is the beautiful thing about illusions:  The illusionist through suggestion and misdirection gets the audience to see what the illusionist wants them to perceive and not his trick.  That video shows a dune buggy going down the road.  That's it.  It doesn't show anything that establishes the fuel source or type.  Stan Meyer told his audience a story:  That the water he poured into a tank got electrolyzed and was used as the fuel, and that it took very little energy to electrolyze the water.

What is not in dispute:  No one has ever reproduced Stan Meyer's over unity electrolysis claims.  Many have tried.  Stan Meyer's claims run counter to established physics.  Stan Meyer was found to have committed an "egregious fraud" upon his investors by an Ohio trial court judge.

While physics will always have room to improve, it takes evidence to get there.  Evidence that Stan Meyer was anything more than a con artist  is sorely lacking.

[magpwr]

Stefan, that is the beautiful thing about illusions:  The illusionist through suggestion and misdirection gets the audience to see what the illusionist wants them to perceive and not his trick.  That video shows a dune buggy going down the road.  That's it.  It doesn't show anything that establishes the fuel source or type.  Stan Meyer told his audience a story:  That the water he poured into a tank got electrolyzed and was used as the fuel, and that it took very little energy to electrolyze the water.

What is not in dispute:  No one has ever reproduced Stan Meyer's over unity electrolysis claims.  Many have tried.  Stan Meyer's claims run counter to established physics.  Stan Meyer was found to have committed an "egregious fraud" upon his investors by an Ohio trial court judge.

While physics will always have room to improve, it takes evidence to get there.  Evidence that Stan Meyer was anything more than a con artist  is sorely lacking.

hi MarkE,

There was a person mentioned pjkbook.pdf whom is based in India.
He was the only one whom came close in achieving in what Stan Meyer did i think 6lpm using only 0.5Amp at 12volts.After the news he was threaten by many related to the "O" industry.
To protect his family he went silence on his project after that.But he did manage to release tips before the silence.

The old method is to condition the stainless steel rods for few weeks which the surface have been made rough.The oxides will start to form on the inner(outwards) and outer rod(facing inwards).
Once the oxides is formed on tube the current draw will be significantly reduced and the produce of bigger bubble starts to be produced.

Enough with the old method which is waste of time to try."Trust me"

There is this recent discovery which i have seen somewhere in the internet where scientist recently managed to reproduce the bubble production and yet consuming low current without the need to condition the rods for a long period they mentioned 3 months.

They are using "Super Corona Dope" which is applied on the rod which have been made rough to increase surface area.
Unfortunately i cannot my hands on this stuff outside USA.My >$1000USD hho project was aborted partially due to fire safety concern since i'm living in a high rise apartment with no backyard and after looking into the 1000w generator noise spec around 59db.Imagine running a stupid generator in a high rise apartment while you sleep not forgetting the neighbors.    

If you combine the super corona dope on the rods with Dave lawton circuit shown in my youtube:sanjev21.I think the hho output is going to be crazy using low power.

The only hobbyist i know is lasersaber whom used this stuff for his static motor video to prevent arcing and improve performance.

That's all for my 2 cents worth of advise.

[MarkE]

Super Corona Dope was something used in TV repair in the days of CRTs.  It had some nasty solvents in it like they used to have in plastic airplane model glue.

I am evidence driven.  Accounts of people doing one thing or another are fine, but if the claim is extraordinary then it needs evidence more substantial than an anecdote or two.  If you think that there is a way to break water molecules into H[sub2[/sub] and O[sub2[/sub] gas that exceeds Faraday efficiency then please post the specifics and I am sure someone will try it out.  Just think how valuable such a discovery could be to creating economical energy storage for wind and solar as well as many other applications.

[magpwr]

Super Corona Dope was something used in TV repair in the days of CRTs.  It had some nasty solvents in it like they used to have in plastic airplane model glue.

I am evidence driven.  Accounts of people doing one thing or another are fine, but if the claim is extraordinary then it needs evidence more substantial than an anecdote or two.  If you think that there is a way to break water molecules into H[sub2 and O[sub2 gas that exceeds Faraday efficiency then please post the specifics and I am sure someone will try it out.  Just think how valuable such a discovery could be to creating economical energy storage for wind and solar as well as many other applications.

hi MarkE,

That's the word "Faraday" which was mentioned BY the person whom first succeeded in replicating Stanley Meyer.

I no longer kept all the links but i am just showing you some link just base on search "Super Corona Dope"
http://www.youtube.com/watch?v=VPQyxdKidxw

Try to do google search on "Super Corona Dope" HHO if you are lucky you will be pointed to the rather recent article.
I am just condensing the article down to the key points for anyone whom is interested in this project.

Dave Lawton circuit is also sold in ebay in kit or assembled form.One of my video shows even show you how to fix a bug that came with this circuit.
The pin 12 of pll:4046 can be improved further by using suitable resistor to gnd.During the time of my experiment i merely grounded pin to solve.1 or 2 years later i figured out how roughly to tune pll.

Honestly i am no longer interested in this project since it's got no use for me. 
But this project got some serious potentials for those whom are interested.

Curing Super Corona Dope in temp controlled oven is better choice.

That's it from me related to HHO.