Shadow,


looking good!


Hanon,


That first link about Lenz really made me thinking.

Hanon

with the diagram posted their is no way to swap poles with the Figueras style of circuit. the pole will have to switch polarities to work but i could be looking at it wrong.  it seems viable though. it will be just like the magnet in the middle of the coil and hitting the reverse pole button that made the whole page light up according to my understanding. as long as their is a potential difference between the output coil windings it should work and YES ! Hyniq is a great asset to the free energy movement. i have gained a new understanding of the ZPE because of him, sparky, Tesla and a few other Great people.

shadow you have my attention but when you start using 100 v @1 a then you have my full attention. looking good and keep up the great work!
Been fighting a abscessed tooth had to take a two week break but its on like donkey kong now !

I just got my timing boards and MJH11020 transistors in last night. i had a two channel and nine channel board made. below are the scanned pics of the SEXY beasts before assembly. WHOO WHO!

Quote from: marathonman on April 16, 2014, 05:36:02 AM
Hanon

with the diagram posted their is no way to swap poles with the Figueras style of circuit.

Hi Marathonman,

Which diagram are you refering to?


For all:

https://www.youtube.com/watch?v=0x46bAPO24I

This setup is identical to Figuera 1908 patent. I think it would be great if everyone may replicate this system with permanent magnets to simulate one field increasing and one field decreasing.

Note that there is no Lenz effect in the last case shown, BUT there is induction !!!

Regards

Marathonman,


wow, now you made me jalous.  gotta hide my cardboard cirquit with hardwired pen schematic on it... 


Hanon,


the question is: is the amount of induction equal to the test with NN polarity? In an other vid of the same channel it is demonstrated: no. 2 Magnets in Attraction, their poles will be stronger, but the point of connection or iron core between them will become weaker. Moving the coil between the end poles of this SN FE SN bar without to ever cross a pole with a bloch wall will most likely induce only few current.


But this is just a thought and the phenomen should be investigated by replication.


Regards

Hanon, i am referring to Coil between two groups of electromagnets_1.PNG  the poles will have to change to get any current ie... flux cutting one way then the other or are the two pairs the same pole ?

Dieter, thank you for your compliment. these are my first circuit board design and i am a little proud of them. i must of stared at them for hours.(thank you Patrick)
oh and i have one extra of each board available if any one wants them. one 9 channel and one 2 channel