Working SMOT ramp from Tom Ferko ?

[nwman]

@ All

The new thread for my design is at http://www.overunity.com/index.php/topic,2259.0.html. Thanks,

Tim

[supersam]

hey tom,

go back to youtube and search, "magnet powered engine".  now that one looks innteresting!

lol
sam

[d3adp00l]

On the rounded mag video, I have gotten many designs to work by oscilating the rotor which is what was happening that vid. The spinning magnet wasn't fixed to an axle with bearings which allowed it to wander a bit which gave it its rotation. Can he do it again, or for longer, not really its like spinning a top, or a coin.

The other looks like B.S. to me he was playing with a basic v gate and got bored so he put power to the fan in a bowl, wires go away from you and on the far edge of the table, or just a 9 volt battery just outside the bowl. I don't normally like to call hogwash on things, but the speed of rotation is way to constant for a single magnet rotor design. It would be pushed and pulled by the fields it encounters as it travels its path. The assembly doesn't have enough mass to smooth out those herks and jerks.

[magnetman12003]

Hi Guys,

I am back again. 

Right now I can spin 10 pounds of  ceramic ring magnets with about 6 ounces of small stacked neo ring magnets. Thats using two fingers to steady the spinning axle shaft.  This particular motor device is a fast turner with a lot of torque.  I finally found a way.

I am working now to construct a needed part to make this a entirely hands off self powered all permanent magnet motor. 

If I show a movie of me touching it in any way even with two fingers--I will be opening the door for a lot of skeptical comments.  I wont do that.  I have confided all info with two persons I trust should I have problems later.

Read what you can about David Hamels cone motor.  I "GREATLY" simplified a certain principle he uses and added a lot of my own past ideas. The device works and rotates!   I still need to have a two finger touch to keep it running ----ALL THE TIME -----.  My fingers dont push, pull or twist a thing.  They only steady the turning axle shaft.

I plan to obtain a patent pending for this device then I will present a movie and idea to the world for free.   Why the patent pending?  --  To keep big oil money from blocking me in any way.   How complicated is this motor device?  2 large stacked ceramic ring magnets, one small stacked neo ring magnet. axle shaft, and a couple of smaller parts.  Anyone can construct one very inexpensivly. Absolutely no sticky spots at all.   Thats because this is not a track type motor.

I have been working at this for about 30 years and finally I am about 98 percent finished. 

Tom

[hartiberlin]

Hi Tom,
just keep it open source.
Wasting any money on a patent application is lost money...
Please read the thread about open source versus patenting.
Many thanks.

Looking forward to your movie.
Don?t be shy to show it.

Regards, Stefan.