Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Hoppy!!  I`m more than glad to try to give you my best shot at explanation but a will rather refer to a great experimenter that I discover and he has the best EFFECT THAT CAN BE SIMILAR TO NELSON`S SECONDARY ...   Just forget the front circuit and let`s concentrate on the output coil made  with the same arrangement as the video describe...  If this is INCONPLETE info for you, I will try my best a second time..  CHEERS!
https://www.youtube.com/watch?v=bbpso7zAlvU

Pepper,

Notice in this video from the same guy - Arkiver, he is simply overloading his source transformer to the point that the circuit breaker trips at the end of the video and he burns his figure touching it. From his dialogue, his electrical / electronic knowledge is limited and confused. As in the video you posted, he is using polarised electrolytic caps to pass AC current and then says that they are getting hot because of the transformer wire needs to be thinner  ! The videos are nonsense.

[Void]

Hi Void,
I know how it feels. I blew out a channel on my Rigol scope whilst working on the Daly contraption.

Hi Hoppy. Bummer. Yes, it is no fun at all when something like that happens. That is for sure. 
It may be some time before I can afford a new scope.

All the best...

[AlienGrey]

Pepper,

Notice in this video from the same guy - Arkiver, he is simply overloading his source transformer to the point that the circuit breaker trips at the end of the video and he burns his figure touching it. From his dialogue, his electrical / electronic knowledge is limited and confused. As in the video you posted, he is using polarised electrolytic caps to pass AC current and then says that they are getting hot because of the transformer wire needs to be thinner  ! The videos are nonsense.

Hoppy his caps if you look at some of his other vids the caps are none polorised 16volt variety RS do them I ordered some by mistake once for a quick job but had to re order some ordinary ones notice the large size anyway 50/60hz is a crap freq to tune! Just cus he can make vids doesn't mean he is a wiz kid

Allen

[Jeg]

From 1Hz to 4 MHz.

But of course, the higher the frequency the worst the resolution.
Cannot be used to find a frequency linearly.

Cool! Thanks again

It was a pretty good scope though. It was a Siglent.

Shit!!! 
Thanks for describing the incident in case someone will learn from that!

Currently, (last months) i am on Tesla's circuits, learning and fooling around. I see similarities with Ruslan's method but not any OU yet!

[Hoppy]

  Hoppy, Void, and all.
  Talk about waisting time and effort.  i' m done with this guy.
   I called his bluff, he ignores me.
   So, I'll ignore him too.
  Sorry, but... Well, you know... Tried to be nice.

Nick,

Relax mate. He means well, just up the creek without a paddle at the moment. You found it difficult at first with very limited electrical / electronics knowledge, so be patient with him. Hopefully he will tone down his posts and realise that he needs to start learning through building and experimenting at the bench.