Magnetic OU principle, You should really take a look at this !

[Butch LaFonte]

Lumen,
I feel this is what everyone has been looking for.
Making drawing now on our layout. I can't believe this is not drawing more attention from the overunity community, but this is not uncommon when you look back through history. Alot of it is just petty emotions.
Butch

[ramset]

Mr LaFonte

Maybe a headliner on the top of the Forum soon?

You are one special Man [wish I lived closer, I would come and paint your house]

Chet

[lumen]

Butch,

This is a simple toggle arm setup I was planning to build to test a similar principal.
If there is any energy gain it should cause the arm to continue to rock as the magnet outside the steel moves to the outside and pulls the other ends magnet (the one now in the steel) closer to the center.

I may wait now to see your results.

[FreeEnergy]

so where is the video? still waiting...Butch

[Butch LaFonte]

The operational sequence is,
1. Rotor magnets are drawn to flux redirecting side plates.
2. When both magnets line up in near maximun repulsion position, side plates move out.
3. Magnets are now in full repulsion mode and torque is created on rotors.
4. As magnets clear side plates the side plates move back in for next power cycle.
This is just one of very many rotary configurations that can use this basic principle.
See attached, 3D animation coming.
Thanks,
Butch LaFonte