ENERGY AMPLIFICATION

[Bob Smith]

@Forest:  Thanks for the kind words.
@Teets: Thanks for the encouragement.

The only thing I would add at this point is something that came up maybe 6 months ago about using bifilar wire. I did a few experiments pulsing a coil with a perpendicular bifi coil to get a ring effect. When I pulsed the perpendicular bifi coil, there was a definite secondary pulse by induction in the main coil. I think Mags did some work on the bifi idea as well.

Anyway, maybe use of a bifi coil might move us clooooooser to the bulls eye... maybe... Teets?     I don't think the cap-diode placement is hard to figure out. Forest mentioned it from one of Tesla's patents. I've seen it in drawings from his patents that Tito has placed in this thread. 

If the main coil is a shorted bifi, then it's going to have its own built in LC configuration (a point Mags made some time ago), making it easier to get the ring effect. If the perpendicular coils feed into caps in parallel fashion, then it would seem to me that this makes them LC circuits as well.

So, if the coils load the caps in parallel and discharge in series (using a diode), maybe they'll "kick" some TPU butt? 

Take care everybody!
Bob

[phoneboy]

@ TITO
Thinking that the secret is knowing how to harness the difference between the two.
http://www.youtube.com/watch?v=-X5CDjHFruk

[Neo-X]

I think the kick is the sudden increase of voltage when a switch is closed in a very high voltage circuit with load. I am not talking here the bemf because this kick is only occur on the first flow of current and it can produce without inductor and capacitor. Just closing of switch in a very high voltage circuit and you can produce this kick. It also produce radiant energy that causes a stinging sensation to the person who operate the switch. I read this somewhere on the net on tesla's document. Steven Mark also talking about this and he figured it out how to use this kick. The kick that based on tesla's discovery.

[Magluvin]

@Forest:  Thanks for the kind words.
@Teets: Thanks for the encouragement.

The only thing I would add at this point is something that came up maybe 6 months ago about using bifilar wire. I did a few experiments pulsing a coil with a perpendicular bifi coil to get a ring effect. When I pulsed the perpendicular bifi coil, there was a definite secondary pulse by induction in the main coil. I think Mags did some work on the bifi idea as well.

Hey Bob

When you say, perpendicular...

Mags

[Bob Smith]

Hi Mags
I remember this came up before too. I'm thinking about a horizontally wound circular shorted bifi iron wire coil.  A finer gauge copper coil would be wound around it vertically. If the circumference of the horizontal coil is say, 14 inches, the copper coil might only be one inch wide (and the diameter of the iron coil). It's wound vertically, therefore perpendicular to the horizontal windings. The 2 ends of the copper coil would feed into the 2 legs of a cap, which with the proper placing of a diode, would discharge in series into another coil:  Kick - Kick is what I'm thinking.

I'm willing to work on this over the next couple of weeks. Open to any suggestions, note comparisons etc.   

Have to get my beauty sleep (early rise for work tomorrow), but would be willing to think this out and give further details - I don't know if I've clarified what I was saying.  I'll see if I can find the earlier posts I was referring to as well. I know some variation of this came up...
Bob