The Master Of Magnetics "Steven Mark"

[gn0stik]

haha, still not shuttin up I see.

[innovation_station]

i find it funny that you all think there are no batteryies involved in the tpu  there are  batteries in it there has to be

[davidman]

Hi I have made a quick page on Wikipedia on Steven Mark.

http://en.wikipedia.org/wiki/Free_energy_suppression#Steven_Mark

Feel free to edit.

[Mannix]

@IS

tubes eh!!

tim nice  wrie up but

i think a circuit that runs on its self is required using tubes and starts with a small small charge from a magnet
in some of the videos you see sm move the mag a tiny bit  in 2 places why?

well to turn on the osclators and buld up the power  each side  1 is the + and 1 is the  - he flips the magnets right all we have to do to activate the tpu is pinch the tube by that i mean send a pluse of oppsit polarity to the tube 1 for each tube 1 + and 1 - from there i think the osclator will add to its self until runaway  or if the proper cutoffs are installed it will quit climbing at the right level for the cutoffs

is

You think that it's possible to self power a tube circuit just be flicking a magnet against the TPU? What about the 300ma heater current per tube? and the delay while the tubes warm up. What about say 150 Volts minimum HT. And all from two small magnets and no batteries. I suggest before you try, you had better see if you can meet the minimum supply requirements for the heaters and HT first using only a couple of magnets.

good luck.

Regards,

Tim.

Tim,
of course you are  right!

Steven used tubes in the discovery process  and has suggested,many times that they are easier, especially to begin with..he also says that they are faster....this has caused some debate for good reasons...BUT  .. untill a lot of people are prepared to use the information provided rather than make up something new...(like all of us here have done at sometime andcontinue to do so) we will not have used the information that we have been given properly.

The reason that you are being jumped on is that most people have read the beginings of this which is 2 years ago now...

The number of people who are using tubes is VERY low...

It is not because of what you say about the magnet swipe but i supose it might as well be for all the good it does..


Lindsay

[innovation_station]

btw i said a regeneration osc circuit  the heaters are powerd by a dc battery  the osc starts from a mag swipe it starts its osolation from the low voltage pluse created from the mag

but you know what you all figure it out

this is what i thought i would try

do as you think i just thought i would share my thoughts it is way to quiet around here also why feed from some one else i feed from no one 


if you all wanted a tpu maybe you should have started with tubes

its not my fault nobody is working with tubes maybe some of you elete guys should!!!!!
is