Earth Electrical Energy Datalogging Experiments

[Pirate88179]

tishatang:

Thank you for the information.  I don't know if you have seen this video of mine or not but, if you watch this, a few minutes in you will see the 3 different waves all mixed together.  This was taken with my scope hooked to the electrodes in the ground:

http://www.youtube.com/watch?v=qjBAU4HAMfs

What does not show up too well, but can be seen, is the spikes appearing all over the scope.  This went off the scale from the top, to the bottom of the screen.  These spike are what I believe charges my supercap well beyond what the measured output of my electrodes is.

When I get a chance, I will make another video and try to isolate these wave forms a little better.

Again, just to be clear, this was right off of my electrodes...no supercap and no JT circuits were involved.

Bill

[electricme]

@ jeanna,
Thank you for those remarks, it was a fluke I was using my camera when the jump occurred, I will keep my eyes open and see if it happens again.

@freepow,

:)hello everyone, I just made a small Stubblefield coil, core I used was 4 pieces of thick galv - wire taped together, i covered copper wire with a thin lining from inside of old pair of track pants or parachute pants, and iron wire wrapped along side of covered copper wire, length of turns about 6 inches, total of 1.5 layers, DMM leads to copper and iron wire, dry I got .6 -.7v and wet I got .74v and  1 mA, about the same when DMM connected to copper and core, just a small test one with not much current !
Is'nt this really just a battery when you wet it ??

Also I have found a site that sells double cotton covered copper wire !  Is this any good

Welcome to the stubblefield research club  yep, at least you got something, and congrats too, hows the fingers?

Sites or shops that sell cotton covered wire are like hens teeth, I would be very interrested as I am sure others would be also.
Just post the http address so we all can go on a looksee.

@ Bill,
I have been working on EBR software all day, got a few bugs ironed out, got 2 more screens working, I will forward it to you shortly if the Install Creator has compiled it correctly.
I will test the install on my own machine before I send it to you.


@tishatang,
As always, this theory is excellent, I betta get my shuvle and go for a dig and plant me a jucy trannie, (how about a MOT for starters or is this too big), how deep does it need to go?
Lights fadein in my neck of the woods, almost 6pm, so it'l have to wait till tomorra sometime.

@mw383,
Good to see you survived your travels and are back witih us again, you've been missed.

@ALL,
Has anyone come across cosmicgnaler? in their travels on OU or other free energy type sites? Got my reasons for asking.

jim

jim

[Pirate88179]

"@ALL,Has anyone come across cosmicgnaler? in their travels on OU or other free energy type sites? Got my reasons for asking.jim"   

Yes, I have seen him  around and he has commented on some of my Youtube videos.

Bill

[freepow]

Hello again...

@Jim

I sent an E-mail to this place in the UK, to see if the cotton covered copper wire is bare copper or tinned or enamled copper wire with cotton around it, so I will see what they say, anyhow here is the link for you and everyone ! 
Oh and yes I got a little sick of wrapping the material around the copper, but I guess it has to be done !
Was'nt many turns either but still got some power out of it, but when you wet a stubblefield or moisten it...is'nt that practically a battery ?

http://www.wires.co.uk/acatalog/dcc_wire.html

Hope its bare copper wire underneath !!!

[freepow]

  Good news !!! I got a reply, here it was it says...

Sir,
Our listed DCC is Double Cotton on Bare Copper wire . But we can produce
Silk or Cotton on Enamelled or Tinned.

Best Regards

Ray