Working SMOT ramp from Tom Ferko ?

[Duranza]

Thanks for your decision to post it all here... I have been following your progress as well as many others, that may not post and just read like me. I look forward to replicate this in the near future.

[magnetman12003]

Hi Guys,

Here it is. Run with it.

Tom

[magnetman12003]

Hi All,

If any industry or group is interested in building and selling this motor device please contact me directly via E mail. All about this motor setup is posted and the idea can be formatted for whatever materials you might use. You will have to experiment a little.  I recommend a fine tooth 1/4 drive Thumbwheel ratchet available from Sears. The S&K brand 1/4 inch drive.  A 3/8 inch socket was soldered on the end of a brass axle rod in my driver setup.   I will answer more questions about anything on this group site only.

My E mail for industry related questions only is 65t@comcast.net

Thanks,  Tom Ferko

[CLaNZeR]

Hi Guys,

Here it is. Run with it.

Tom

Thanks for this Tom

Could you show us a video of it working so I can get a better picture in my mind.

Looking good though!

Regards

Sean.

[magnetman12003]

Hi All,

Here is a video clip of the motor device in operation with 2 fingers. I am making the needed part to see it as a self runner. I am not pushing, pulling, or twisting a thing in this video. All skeptics please note that.


Tom Ferko