Re-Inventing The Wheel-Part1-Clemente_Figuera-THE INFINITE ENERGY MACHINE

[marathonman]

YES ! FINALLY and Congratulations. welcome to MY world. now reread all my previous posts and visualize what is taking place.
Part G changes the magnetic flux to current ratio, increase, decrease, opposing EMF produced.
Regards,
Marathonman

[seaad]

But creates the part-G the entire OU Effect itself ?

Regards Arne

[marathonman]

That design will be very inefficient. not only is the wire hanging in free air loosing induction also the core HAS to be a closed core. no unnecessary losses.
Part G it's self does not and can not be OU. it reuses the potential in the exciting system to act up on another closed system. it is all about maintaining the pressure in the system and both are a sort of closed systems. 

News about the toroid, while i know the toroid core does work as the original replicator used, it was very finicky and a pain in the back side to balance. so myself and another builder have been discussing the problems about the toroid and both of us came to the same conclusion. the  toroid is peaky due to the parallel inductance on the non active side of the toroid. what this does is give interference to the active side causing it to be very peaky and a bitch to balance.
so i took it upon myself to have a special C core made that will eliminate the the problems and be much easier to balance. after running sims on the core  it seams the C core was very much more smooth in this area and will be much easier to wind and balance. a wide center E I core will work also avoiding the previous issues. as long as it is a closed core.

it will be presented shortly.
Regards,
Marathonman

[seaad]

.

[marathonman]

Here is a pic of my new core i had made. it is a C-Core that is a closed core that will not only be mush easier to balance but much, much easier to wind compared to the toroid.
the second pic is a picture of my adjustable brush holder that is being CNC milled.

Regards,
Marathonman