Friedrich Luling Magnet Motor

[Ufopolitics]

Gentlemen
I believe this has already been mentioned
However
Note to UFO politics


Here at this forum there was a section set aside for builders sharing their work
It allows management of contributions by host/builder ( would be UFO in this case)


Sometimes it is necessary to limit overzealous off topic contributions in "builders boards"
And host ( UFO?) can manage,organize or remove inappropriate contributions.


For clarity these sections once established are like separate forum areas that can have multiple
Threads !


I highly recommend this for builders


Respectfully submitted
Chet K


Ps
I will be sending Stefan a note later on another topic
If you like I can let him know to watch for request ( he is always having many ongoing projects
And does get overwhelmed with requests at times, this however should go to front of list if requested


IMO
People who take the time to build and share are the most valuable asset the community could ever have !
And their time should never be wasted or disrupted!
Not just one mans opinion...

Hello Ramset,


Thanks for all your help!!
And yes, I did write to Stefan Hartmann about opening a Luling Builder's Thread where I will expose all details on my setup, plus future builds.


Kind Regards my friend!!




Ufopolitics

[knovos]

Very inspiring. I immediately went to the drawing board to make a design. I was wondering if it is possible to make the pullback (neutralization) mechanical instead of compressed air. That mechanism should be adjustable as well. I will be back here too.

[activ25]

With what software have draw that ? is it a free software ?

[knovos]

With what software have draw that ? is it a free software ?

I use Autodesk Fusion 360. There is a free license available for hobbyists. Fusion 360 is THE CAD-software used in the 3D printing world (in the maker/DIY segment) but also high-end professional if you pay for a more expensive license. The hobbyist license is more than enough to make complex designs.

[knovos]

This is my idea for the adjustable magnet and how it might be mechanically neutralized. The small disk is attached to the turntable and is adjustable for the right moment. He bounces against the larger round disc that is attached at the bottom of the magnetholder. The magnet will be pushed outwards (neutralized). I am a 3D printing specialist, so everything will be made with this technique, except some metal bearings, threads, nuts, washers, and such.