Friedrich Luling Magnet Motor

[kolbacict]

Well, we can do that too.
It was done a few years ago.
Only not pneumatics, but an electromagnet-solenoid pulls off a permanent magnet.
Device V-gate.
https://www.youtube.com/watch?v=gjAQUkHuTn8

[synchro1]

I am pulsing a ferrite rod with a reverse bias neo backing magnet through the center of a ring magnet and shiting the field polarity of the ring. 

https://www.youtube.com/watch?v=GeeivXPsuro

The rod retracts itself and supplies a reverse pulse to boot. This power pulse is free power. This free pulse is equal in power to the primary input pulse. This motor would be Overunity by the percentage of BEMF recovered from the coil's backspike!

[synchro1]

There may be an additional sheer to push pull power ratio to the already OU design. There appears to be a strong advantage!

Coupled tub motor's would allow for accurate output power measurements.

Lulling oscillates ferrite between magnet poles with a clumsy cam and shaft. Same trick.

[Ufopolitics]

Well, we can do that too.
It was done a few years ago.
Only not pneumatics, but an electromagnet-solenoid pulls off a permanent magnet.
Device V-gate.
https://www.youtube.com/watch?v=gjAQUkHuTn8

Hello kolbacict,

Lüling Motor does not uses electromagnets, nor any electricity to run,...and that is the main point...
The moment that an electromagnet is utilized, it is just another Electromagnetic Motor, out of the thousands types and models out there...period!!

Now find me out there, a Magnetic Motor, that only uses Permanent Magnets and Compressed Air...none, except Lüling.

I could have done that too, of putting electromagnets galore...as well... 

[synchro1]

Luling is "Sheering" magnet poles with a ferrite keeper. The principle of operation is unique and distinct regardless of the power mode.