Confirmation of OU devices and claims

[TinselKoala]

You know with all the brains on this site I am sure we could do something constructive.  Instead it's one faction against another faction all the time.  It's just sad folks.

I hope you noticed that that string of 20 NE-2 neons in series with 16 of them lit up (90 volts each) was just being held by my fingers at one end, and not connected to anything at the other end. Like I said, a powerful e-field emitter that can and will wreak havoc with instrumentation. And it could be made even stronger quite easily but then I wouldn't want to run it in the house.
Is that OU?


Back to my three videos and the questions for RF. The first video shows a great gain in VARs over input power in Watts. The phase shift measurement that _indicated_ in phase was an error introduced by the current measuring method I demonstrated which introduced a phase shift of its own. I wanted to know if RF's Overunity was Overunity in VARs, and whether or not 1) he had measurements he could show of his own, and 2) whether he would point out the phase shift error as Itsu did.
The second video shows overunity measurements in the Partzman bft, and _fully accounts_ for the phase shift problem with its careful layout and use of non-inductive precision load and current sense resistors. The phase shift is evident and correctly displayed on the scopes that I and others have used, both low and high end equipment. I wanted to know if RF's Overunity was Overunity measured in power dissipated by a noninductive resistor in a situation of high, known phase shift incorporating a resonating coil as demonstrated there. Unfortunately RF has been too busy (typing and talking?) to view that very significant demonstration that most of the rest of you have seen.
The third video shows overunity in TinMan's bifilar LED driver circuit by having the load and the internal LEDs, 4 in all, shining brilliantly with ZERO current shown on two inline ammeters, even in the most sensitive 2000 microamp range. I used cheap meters but this effect has been reproduced with all kinds of meters cheap and expensive. My Fluke 87-III acts the same way and is even more sensitive. I wanted to know if RF's Overunity was this kind of Overunity, where meters indicate zero current supplied to a resonating loop but the load is still running along happily.

Three possible types of Overunity indications. But RF's is somehow different? And his measurements somehow more valid? OK, I'm willing to consider that... with evidence. Unfortunately, walls of gobbletext and anecdotes about other people's work done in the misty past do not count as evidence for me.

[ramset]

TinselKoala quote"..If you want to discuss this project PLEASE somebody start another thread on it"
end quote.
https://overunity.com/18282/tks-akds-ssstc-build-discussion-investigation/new/#new  is this a proper tittle ?,if so I will repost all the pics and such from    your initial reference on previous page to above link .

[rickfriedrich]

Nick,
I'm the worst critic of my videos. I delete them all the time. The truth is that I haven't had the time to do quality videos. Sometimes I do forget to post the schematic of what I was showing, or to bring the camera close. I have deleted a good number of videos that I made and never uploaded because they just were not good enough. I did get a proper mic however, and that was an improvement. I do show meter readings all the time, so this shows that you really haven't watched my videos. Like I said, I am making a new website right now and I'll organize the more relevant videos from those that are obsolete and just taking up space and need to be deleted.

But you have to understand that I did not do these videos for you or for people just starting out. They are me talking to customers. They want those rambles.    So it is a matter of doing something rather than nothing. I guess the point is that my videos are gifts so who can complain. If you don't want the gift then you can ignore them as you do what I write here.

The other point is that it is not my goal to prove OU in a video, or to always show the same measurements. I am dealing with many different topics. The goal is not to prove OU but show people how to maximize this. You guys keep making all these fallacies to try and discredit me. That is your only goal the last month. I rarely see anything useful from the whole lot of you. Sometimes something said is good, but somehow I am supposed to do everything I guess. I never came here to prove OU, even if someone else may have. If you are not satisfied with the information or videos then so be it!

    Listen carefully:  I have watched his videos, and still don't know all the details that I mentioned in my last post. It's hard to watch a two hour video, about his opinions, without careful measurement to go along with it. But, I did watch it. LOL.   Yet, you say "it's all there". Really?
    So, A, now that you know all that needs to be done and are up to speed, why don't you show the results. Like itsu has done. Perhaps you can show some actual gains. That would help. As most of us have watched at least his more relevant videos, and still don't get it. But, getting it, is not the same showing it working as a OU device.
   Kapanadze also has a patent. Did that help to produce a working replication? He also talked about the cause of free energy, yet, no one can replicate what he has shown many different times, as yet. So, perhaps you can tell us what is missing? And show some gains that can be measured and replicated.

[TinselKoala]

Some facts:


Tinsel Koala does not remember so I am going to post the overunity experimental circuit done by the Ukrainian government's agricultural college.  We corresponded for some time.

Here are some of Rick's REAL CUSTOMERS in the REAL WORLD.



https://www.youtube.com/watch?v=Ucvc38NCg9k


https://www.youtube.com/watch?v=ShXBAniR1JY
https://www.youtube.com/watch?v=ZX_rlCAFQxs


These are customers who have purchased his products.

Maybe you can explain why people who have OverUnity systems running in their homes still need battery chargers. I thought you just swapped them back and forth while running the load and they "self sustain".

One of those videos shows the amazing charging of a "non rechargeable" 6 volt battery. But I have an even more amazing video for you, where I use a bedini-like motor system running on a single AAA battery to charge up a C battery.  Is that OU?

[NickZ]

Nick,
I'm the worst critic of my videos. I delete them all the time. The truth is that I haven't had the time to do quality videos. Sometimes I do forget to post the schematic of what I was showing, or to bring the camera close. I have deleted a good number of videos that I made and never uploaded because they just were not good enough. I did get a proper mic however, and that was an improvement. I do show meter readings all the time, so this shows that you really haven't watched my videos. Like I said, I am making a new website right now and I'll organize the more relevant videos from those that are obsolete and just taking up space and need to be deleted.

But you have to understand that I did not do these videos for you or for people just starting out. They are me talking to customers. They want those rambles.    So it is a matter of doing something rather than nothing. I guess the point is that my videos are gifts so who can complain. If you don't want the gift then you can ignore them as you do what I write here.

The other point is that it is not my goal to prove OU in a video, or to always show the same measurements. I am dealing with many different topics. The goal is not to prove OU but show people how to maximize this. You guys keep making all these fallacies to try and discredit me. That is your only goal the last month. I rarely see anything useful from the whole lot of you. Sometimes something said is good, but somehow I am supposed to do everything I guess. I never came here to prove OU, even if someone else may have. If you are not satisfied with the information or videos then so be it!

    Rick: Ok, well, I like the tone of your last comments and post. They are easier to deal with, than previously. 
     You know that I don't know all about you, what you've done, or shown, or said. But, I wonder if you know anything about me, other than being a "troll", that is. Have you looked at my videos, at all?  No? So, we are both lost in space, as far as that goes. Or what itsu has done, or TK, or Hoppy, and other replicators of these supposed free energy contraptions. What guys like me have done through the years here, also. Hoppy and I have over 8000 posts between us here, and at what we call the asylum. TK has almost twice as many posts, or even more than that, including other sites. Maybe that is not important to you, but, you must recognize that WE are not trolls, not believing in free energy, and doing what we can to disrupt it, when possible. Just the opposite.
     I have recommended that you make a video, for us. Not for your customers, clients, or those that you've deal with before, this time.   Will you do that, for us?  Please... 
   And yes, showing updated improved scope close-ups, and output readings, as mentioned by the other guys, here. So, that we can see the scope readings, with all the bulbs facing the camera this time.  I'm sure that would please everyone following you on this venture. As that video would be for us. And anyone else interested.
   You see, I have watched your videos. But you haven't watched mine, or I'd know it. 
   The idea is not to prove or disprove anything, but just to observe the results. That's all. That is what I try to do on my videos.  And TK does with his, "is this OU".  No claims, just showing what is happening. No need to get personal, or judgemental. 
   I am not blind, or dumb, and can see that you MAY have something there, worth pursuing.   
   Pura Vida,           
                   NickZ