Muller Dynamo

[skycollection]

About the sewing bobins, i am not ussing this kind of coils,and the acetate plastic that i use in my bobins, is a good way to make a good coil...!
I have a new coil, in a few days i will post a new video for the presentation of my new coil, i am ussing gauge 21 wire, and low resistance ohms, this coils are going to be placed in pairs in my dinamo-motor.

[Magneticitist]

for me the thing about the Kromrey is, when i really think about it, it sort of starts to make sense but *not really*, as i sort of start thinking somehow no matter what this is possible, but only if the arrangement is somehow offering sufficient bemf already in the unloaded situation then when loaded this bemf decreases with the using of a biasing current created by the spinning coils, but then why does a bulb light, draw decrease, AND speed go up?

could never figure it out then after reading to a certain point in the patent trying to identify the specifics of the outer magnet windings i read

"the magnets 101', 101'' of the stator are surrounded by respective energizing windings 109', 109'' which are connected across a suitable source of constant direct current, not shown."

page 7 left paragraph  patent 3374376

after reading that it started to make more sense...

unless someone can explain what else that could mean other than what i think it does

[Cap-Z-ro]

What I get from Vicktor Schauberger is that water current is similar to electrical current in its general properties.

I know that the pressurized release of water is more powerful than more loosely flowing water...AND that the pressurized release of water is pulsed is far more powerful than a steady stream of pressurized water.

I also seem to recall that Tesla believed the capacitor to be the key to free energy.

To me it appears that the bang of a dead short and collection of the fall out may be less efficient than build up of potential.

Just my thoughts and objective once I am able to start on Clanzer's experimental unit...I wouldn't be too too disappointed if someone here were to beat me to it.

After all, we are all a 'Johnny come lately' in this field of research...once its done, it will not matter anyway.

Regards...

[oscar]

..."the magnets 101', 101'' of the stator are surrounded by respective energizing windings 109', 109'' which are connected across a suitable source of constant direct current, not shown."

quoted from page 7 left paragraph Kromrey patent 3374376

Hi Magneticitist and all,
this quote is a great find.
I am thinking: Is it correct to say, that Kromrey's 'energizing windings around the stator magnets' serve the same purpose as the 'biasing magnets' in RomeroUK's Muller motor-generator (since Kromrey's 'DC energizing windings' form electro-magnets that bias his stator-magnets)?

[AbbaRue]

I can see a similarity between the Neo. Magnet passing through the 2 coils in the Muller Dynamo,
and the 2 coils of the Kromrey passing between the Neo. Magnets. 
Only in the one the magnets are doing the moving and in the other the coils are doing the moving.
You would only have to wind the Muller Dynamo using Trifilar windings instead of litz wire. 
And maybe the litz wire is doing the same thing, only with 7 strands instead of 3. 
Maybe someone can replace one set of coils in there replication with Trifilar coils and see if it make a difference.