Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[dole]

I am sorry for repeating information but only to adjust the focus a little.
They talk very clean and slow so you may understand almost everything, I hope.

http://www.youtube.com/watch?v=tu84y83_AYg

d.
(high-low, fast-slow, and yes off course dipole :-)

[dllabarre]

I am sorry for repeating information but only to adjust the focus a little.
They talk very clean and slow so you may understand almost everything, I hope.

http://www.youtube.com/watch?v=tu84y83_AYg

d.
(high-low, fast-slow, and yes off course dipole :-)

Wesley

Just from watching the video I understand what he's doing but he might be telling us some important configuration instructions that I can't understand being it's in Russian.

If you get some free time would you please translate this video?

Many of us would really appreciate it.

Thank you,
DonL

[PARAV]

Well Guy's... may I just make mention of a few points: This thread and it's content I find of great interest, I have not made any contributions personally, with respect to the subject matter. As an electronics engineer myself I readily recognise from the various postings exists a wealth of knowledge here from various members both new and old. Like many others I very much enjoy following the progress and the experimental work by all... However it would be a great shame to see this thread spoilt by differences of opinions etc...and trivial arguments that tend to mar the overall interest here. Among the casual experimenters exist some cleaver - knowledgeable people... so with the greatest of respects please refrain from attacking each other and remain  focused in combining your individual skills and knowledge for the better good!! Kind Regards

[stivep]

Wesley

Just from watching the video I understand what he's doing but he might be telling us some important configuration instructions that I can't understand being it's in Russian.

If you get some free time would you please translate this video?

Many of us would really appreciate it.

Thank you,
DonL

Yes he is talking about Tesla  configuration  and when you put near vicinity of that device more  secondary windings not connected they show corona

understandable....


Than he says that he is able to put many secondary coils unlimited number
and take  say 10KW out of (primary) configuration that is utilizing only 200W

Than he demonstrate 2 light bulbs (500Wx2)
but he does not show if there is BEMF
And how this affect (primary config)

Well.
I have huge respect to Russian.
Definitely Kapanadze is not  the joke.
So every information is important.

What I think

Air coils made air transformer

The energy induced in any one of the coils placed  within vicinity of electromagnetic field   of primary Tesla config. should affect it as well.
He showed at the beginning that when he placed not connected Secondary coil than  Voltage and Current did not change .. 9 but coil wans not under load)

He also mentioned that he has double primary coil ( copper tubing at the bottom of the life  Tesla transformer ( connected)
He also mentioned about double secondary winding of life  Tesla transformer ( connected)
but confusion is in fact that it looks like he was not talking about bifilar secondary winding of life  Tesla transformer ( connected) where one of windings is not connected
( I'm not sure)


One way of understand this is that
secondary of life  Tesla transformer ( connected) has 2 winding  but second winding  from bifilar is not connected and this is the one that has corona.

that this one interacts with  additional Tesla secondary coils placed in near by.

Second way of understand this is that
There is no bifilar on secondary winding of life  Tesla transformer (connected)
But secondary are additional  secondary coils placed in near by.


Transformer is transformer and all of the physics is to apply.

If you do not have ferrite core than coefficient of coupling is equal of Q of the air=1 . But all of the rules of ratio works the same way.

Coil by itself is resonant circuit.

series, parallel and mix in one device at the same time. The difference is resonance frequency for all of them.(it is different)

He also stays that at his device connected to four coils  he use 50Hz 220V to drive light bulbs (I'm not sure about 220v)


Than you will notice  capacitors on the top of working configuration with 2 bulbs.

what it looks like he tunes coils to specified frequency of choice.(by the most of light from the bulbs I assume..as he does not have any lab equipment)

Well believe me Russians  can do it with out it.


This is my note after very fast viewing of this video.

Yes it is worth your time.
I understand that he call for money  for development 10KW from 200W
that is always suspicious.
From the other hand
He is old. He has not much to gain. Russian pride.

Wesley
 

[stivep]

Wesley

Just from watching the video I understand what he's doing but he might be telling us some important configuration instructions that I can't understand being it's in Russian.

If you get some free time would you please translate this video?

Many of us would really appreciate it.

Thank you,
DonL

Yes he is talking about Tesla  configuration  and when you put near vicinity of that device more  secondary windings not connected they show corona

understandable....


Than he says that he is able to put many secondary coils unlimited number
and take  say 10KW out of (primary) configuration that is utilizing only 200W

Than he demonstrate 2 light bulbs (500Wx2)
but he does not show if there is BEMF
And how this affect (primary config)

Well.
I have huge respect to Russian.
Definitely Kapanadze is not  the joke.
So every information is important.

What I think

Air coils made air transformer

The energy induced in any one of the coils placed  within vicinity of electromagnetic field   of primary Tesla config. should affect it as well.
He showed at the beginning that when he placed not connected Secondary coil than  Voltage and Current did not change .. 9 but coil wans not under load)

He also mentioned that he has double primary coil ( copper tubing at the bottom of the life  Tesla transformer ( connected)
He also mentioned about double secondary winding of life  Tesla transformer ( connected)
but confusion is in fact that it looks like he was not talking about bifilar secondary winding of life  Tesla transformer ( connected) where one of windings is not connected
( I'm not sure)


One way of understand this is that
secondary of life  Tesla transformer ( connected) has 2 winding  but second winding  from bifilar is not connected and this is the one that has corona.

that this one interacts with  additional Tesla secondary coils placed in near by.

Second way of understand this is that
There is no bifilar on secondary winding of life  Tesla transformer (connected)
But secondary are additional  secondary coils placed in near by.


Transformer is transformer and all of the physics is to apply.

If you do not have ferrite core than coefficient of coupling is equal of Q of the air=1 . But all of the rules of ratio works the same way.

Coil by itself is resonant circuit.

series, parallel and mix in one device at the same time. The difference is resonance frequency for all of them.(it is different)

He also stays that at his device connected to four coils  he use 50Hz 220V to drive light bulbs (I'm not sure about 220v)


Than you will notice  capacitors on the top of working configuration with 2 bulbs.

what it looks like he tunes coils to specified frequency of choice.(by the most of light from the bulbs I assume..as he does not have any lab equipment)

Well believe me Russians  can do it with out it.


This is my note after very fast viewing of this video.

Yes it is worth your time.
I understand that he call for money  for development 10KW from 200W
that is always suspicious.
From the other hand
He is old. He has not much to gain. Russian pride.

Wesley