Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[hartiberlin]

Hi Wesley,
would be great, if you could produce your needed input wave with a selfmade oscillator circuit and
power all with a 12 Volt battery.

This way you could also measure the DC power input via a low pass filter.
So before the low pass filter directly at the battery you have a pure DC power input
which could be easily measured via a DC amperage meter and a voltmeter directly at the battery.
If your LC lowpassfilter is 0.001 Hz or so, this will be good enough to show almost pure DC input power.


Okay, here is a good Flash animation explanation to get familiar with VSWR technology.

http://www.fourier-series.com/rf-concepts/flash_programs/Reflection/index.html


Regards, Stefan.

[Kator01]

Hello all,

whe I saw Wesley´s vid about the sparkgap-evaluation a memory came alive from a time I was evaluating tungsten-electrodes for a project not related to this subject here. The reason for my reseach then was to find an no-radioactive material with a very low work-function. May I introduce to you this electrode-material here

http://www.multistriketungstens.com/

Attention to the paragraph "science a bit" will give you the clou of why I post this here.
Its for those of you who are able to manufacture a DIY-sparkgap.

Regards

Kator01

[ronotte]

@John M,
please read the forest's answer. Tanks
@all,
That's what I was looking for...FINALLY...I GOT IT...it speaks for itself
Roberto

[Kator01]

@ronnote,

The complete project is on DELAMORTO thread just have a look there.

Where do we find this thread ?

Can you post a schematic of the whole setup of yours ,please ?

Regards

Kator01

[Khwartz]

The essense is  IMHO to create very strong electromagnet  without Lenz influence , and then pulsing it as fast as possible. Just that is enough. Then wind secondary and tap energy. stiveip proved it by using caduceus coil. It's my personal opinion.

Hi Forest! What is IMHO please?